Summary for Test 2018-07-10-2-1
Test performed: ASTM A370-15Project Information
Project Identifiers | Project ID: 213062 DEA: 07292304 EFIS: 0712000109 |
---|---|
DIST-CO-RTE-PM | 07-LA-5-25.6/26.0 |
Award Date | 04/04/2018 |
Closeout Date | 06/08/2020 |
Work Description | WIDEN OFF-RAMP, WIDEN BRIDGE, AND CONSTRUCT CONCRETE BARRIER. |
Location Description | LOS ANGELES COUNTY IN LOS ANGELES FROM 0.1 MILE SOUTH TO 0.2 MILE NORTH OF ROUTE 5S/5 SEPARATION |
QA Service Level | 1 (Verified on 04/18/2018) |
Sample Information
Sample Taken Date | 07/10/2018 | Sample Unique Key | 2 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 07/11/2018 |
Sample type | Quality Assurance | A brief description of the sample | 1-1/2 X 26 F1554 Gr105 |
The quantity of what the sample constitutes | 1 of 3 anchor bolts | From where was the sample collected | Distributor |
First name of sampler or witnessed by | Scott | Last name of sampler or witnessed by | Leavitt |
Title of sampler | QA Inspector | Telephone number of sampler | 510 590-0116 |
Laboratory sample identification | Unknown | Linked DIME Sample ID | Unknown |
The fabricator/manufacturer/facility name | Utah Pacific Bridge | Transportation Laboratory (TL) Number | Unknown |
Inspector Lot Number from the Transportation Laboratory (TL) Form | S28-180-18 | Structure unique identifier | Not set |
Structure name | Not set |
Material Information
Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | N/A |
---|---|---|---|
Heat Number(s) | 72073249 | Nut Mfg. Lot Number(s) | TJV |
Washer Mfg. Lot Number(s) | 293648 | Bolt Specification | F1554 Gr105 |
Bolt Length(s) | 26" | Nut Specification | A563 GrDH |
Washer Specification | F436 | Finish | HDG |
Diameter/Size | 1-1/2" | Bolt Mfg. Lot Number | N/A |
Rocap Test Requirement(s) | No | Lubricant Requirements(s) | Yes |
Test Details
DIME Sample ID: 2018-07-10-2
DIME Test ID: 2018-07-10-2-1
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM A370-15: Standard Test Methods and Definitions for Mechanical Testing of Steel Products (Tensile - Round Sample)
Test Release Date: 2018-08-13
Test Results
Number of Samples: 1
Input Type: Measured
Tester's full name: Brian
Date of test: 07/31/2018
UTM: 67KIP
Temperature: 72 f
Num | Sample | Heat Number | Diameter (in) | Area (sqin) | Stress at Offset (psi) | Tensile Strength (psi) | Elongation in 4 x d (%) | Tested By |
---|---|---|---|---|---|---|---|---|
1 | 1 | 72073249 | 0.505 | 0.2 | 131887 | 146750 | 17.4 | Brian |
General comments (publicly viewable) (Max 1000 characters):
Test Graph
Source: Partner Data Point FileTest graph for the Sample
Test was verified on 8/6/2018 ✔