Summary for Test 2017-09-19-14-1
Test performed: ASTM A370-15Project Information
Project Identifiers | Project ID: 211796 DEA: 073X8704 EFIS: 0713000241 |
---|---|
DIST-CO-RTE-PM | 07-LA-105,405-R2.5,20.5/R21.1 |
Award Date | 12/29/2016 |
Closeout Date | 04/08/2020 |
Work Description | SLOPE RECONSTRUCTION AND PAVEMENT REPAIR |
Location Description | LOS ANGELES COUNTY IN AND NEAR HAWTHORNE FROM EL SEGUNDO BOULEVARD UNDERCROSSING TO ROUTE 105/405 SEPARATION |
QA Service Level | 1 (Verified on 03/14/2017) |
Sample Information
Sample Taken Date | 09/19/2017 | Sample Unique Key | 14 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 09/25/2017 |
Sample type | Quality Assurance | A brief description of the sample | F1554 Anchor Rods Nut Washers |
The quantity of what the sample constitutes | 2 | From where was the sample collected | Job Site |
First name of sampler or witnessed by | Prakash | Last name of sampler or witnessed by | Patel |
Title of sampler | Unknown | Telephone number of sampler | Unknown |
Laboratory sample identification | Unknown | Linked DIME Sample ID | Unknown |
The fabricator/manufacturer/facility name | Nucor, Dyson, Wrought | Transportation Laboratory (TL) Number | NA |
Inspector Lot Number from the Transportation Laboratory (TL) Form | L1105117 | Structure unique identifier | Not set |
Structure name | Not set |
Material Information
Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | |
---|---|---|---|
Heat Number(s) | Nut Mfg. Lot Number(s) | ||
Washer Mfg. Lot Number(s) | 297021 302919 | Bolt Specification | F1554 |
Bolt Length(s) | 60 50 | Nut Specification | A194 / DH |
Washer Specification | F436 | Finish | A153 / F2329 / Plain |
Diameter/Size | 2.5" / 2" | Bolt Mfg. Lot Number | 3071629 58030825 |
Rocap Test Requirement(s) | Lubricant Requirements(s) |
Test Details
DIME Sample ID: 2017-09-19-14
DIME Test ID: 2017-09-19-14-1
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM A370-15: Standard Test Methods and Definitions for Mechanical Testing of Steel Products (Tensile - Round Sample)
Test Release Date: 2017-10-09
Test Results
Number of Samples: 1
Input Type: Measured
Tester's full name: Fred
Date of test: 09/28/2017
UTM: 67KIP
Temperature: 72 f
Num | Sample | Heat Number | Diameter (in) | Area (sqin) | Stress at Offset (psi) | Tensile Strength (psi) | Elongation in 4 x d (%) | Tested By |
---|---|---|---|---|---|---|---|---|
1 | 1 | 3071629 | 0.505 | 0.2 | 65017 | 93310 | 26.6 | Fred |
General comments (publicly viewable) (Max 1000 characters):
Test Graph
Source: Partner Data Point FileTest graph for the Sample
Test was verified on 10/2/2017 ✔