Summary for Test 2023-05-31-63-8

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 993159
DEA: 08323034
EFIS: 0812000059
COOP: 081703
DIST-CO-RTE-PM08-RIV-60-18.8/19.6
Award Date05/04/2021
Closeout DateNot set
Work DescriptionProject Phase 2 (project) proposes to replace the existing hook ramp configuration along westbound (WB) SR-60 at the SR- 60/Moreno Beach Drive interchange with a partial cloverleaf configuration
Location DescriptionSR-60 & Moreno Beach Interchange
QA Service Level2 (Verified on 07/27/2021)

Sample Information

Sample Taken Date05/31/2023 Sample Unique Key63
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing06/16/2023
Sample typeVerification A brief description of the sampleJMF 3/4" RHMA-G-SP 0.5% LAS
The quantity of what the sample constitutes4 Bags Of Agg, 1 Bag each of Scrap & Hi-Nat From where was the sample collectedManufacturer
First name of sampler or witnessed byVictor Last name of sampler or witnessed byQC
Title of sampler Telephone number of sampler
Laboratory sample identification0322G-23 Linked DIME Sample ID
The fabricator/manufacturer/facility nameAll American Asphalt- Perris Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)91-33-0005
The fabricator's/manufacturer's product name for the sample The fabricator/manufacturer designation for the sample
The plant number A detailed description of where the material sample was collectedBelt Cut at All American Perris
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size3/4 inch
The concrete mix design number106835 Lot number
Sublot number Aggregate Mix Number

Test Details

DIME Sample ID: 2023-05-31-63
DIME Test ID: 2023-05-31-63-8
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2023-09-12

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 06/27/2023
Weighted percentage of particles (by mass) that were flat and elongated: 0 %
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 9/12/2023