Summary for Test 2023-02-13-49-8
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 214341 DEA: 081J2004 EFIS: 0817000237 |
---|---|
DIST-CO-RTE-PM | 08-SBD-15-R21.5/R22.0 |
Award Date | 11/16/2021 |
Closeout Date | 10/02/2024 |
Work Description | EXTEND DECELARATION LANE |
Location Description | SAN BERNARDINO COUNTY NEAR HESPERIA FROM 0.1 MILE NORTH OF ROUTE 15/138 SEPARATION TO GISH OVERHEAD |
QA Service Level | 1 (Verified on 06/23/2021) |
Sample Information
Sample Taken Date | 02/13/2023 | Sample Unique Key | 49 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 02/21/2023 |
Sample type | Verification | A brief description of the sample | PSUE 3/8" HMA-A-SP R15 0.5% LAS |
The quantity of what the sample constitutes | 4 Bags Coldfeed Agg., 2 Bags Rap | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Richard | Last name of sampler or witnessed by | Balandra |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 0152A-23 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | Vulcan Corona | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-33-0027, 91-33-0073 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Belt Cut at Vulcan Materials-Corona Drum | |
Where the material sample would have been placed if not sampled | Asphalt Paving | Primary Aggregate Nominal Size | 3/8 inch |
The concrete mix design number | 424103 CORD SJR | Lot number | |
Sublot number | Aggregate Mix Number |
Test Details
DIME Sample ID: 2023-02-13-49
DIME Test ID: 2023-02-13-49-8
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2023-07-05
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 02/26/2023
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 7/5/2023 ✔