Summary for Test 2022-08-09-12-8
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 993847 DEA: 081M8604 EFIS: 0822000056 |
---|---|
DIST-CO-RTE-PM | 08-SBD-15-180.2/186.2 |
Award Date | 06/23/2022 |
Closeout Date | 12/12/2022 |
Work Description | COLD PLANE AC PAVEMENT AND PLACE RUBBERIZED HMA (GAP GRADED). |
Location Description | SAN BERNARDINO COUNTY ABOUT 43 MILES NORTH OF BAKER FROM 0.5 MILE SOUTH OF YATES WELL ROAD OVERCROSSING TO NEVADA STATE LINE |
QA Service Level | 1 (Verified on 12/05/2022) |
Sample Information
Sample Taken Date | 08/09/2022 | Sample Unique Key | 12 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 08/10/2022 |
Sample type | Verification | A brief description of the sample | Aggregate |
The quantity of what the sample constitutes | 6 - 5 gallon buckets | From where was the sample collected | Source |
First name of sampler or witnessed by | Mark | Last name of sampler or witnessed by | Daniels |
Title of sampler | Cunsultant | Telephone number of sampler | |
Laboratory sample identification | 22-JMF-0118 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | Blue Diamond | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | Unknown |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Plant | |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2022-08-09-12
DIME Test ID: 2022-08-09-12-8
Testing Lab: CT HQ - Sacramento Aggregate Testing Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2022-08-12
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Jay Horton
Date of test: 08/12/2022
Weighted percentage of particles (by mass) that were flat and elongated: 0 %
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %
General comments (publicly viewable) (Max 1000 characters): Flat and elongated particles (% by mass at 5:1)
Test was verified on 8/12/2022 ✔