Test 2019-11-15-16-5 (AASHTO T324-14) Summary

Project Information
Project Identifiers
DEA: No Project
DIST-CO-RTE-PM---
Work DescriptionSpecial project identifier for material not associated with a project
Location DescriptionNot set
Sample Information
Sample Taken Date11/15/2019 Sample Unique Key16
Will the laboratory/organization for which you are a member perform testing on this material sample?No Date that the sample was received by the laboratory/organization performing the testing11/15/2019
Sample typeQuality Control A brief description of the sampleLaboratory-Batched 1/2-inch Type A HMA (eq. PG 64-10)
The quantity of what the sample constitutesJMF Submittal From where was the sample collectedOther
First name of sampler or witnessed bySampler First Name Last name of sampler or witnessed bySampler Last Name
Title of sampler Laboratory sample identification
The fabricator/manufacturer/facility nameVulcan Pleasanton Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name
Material Information
Material TypeHot Mix Asphalt HMA TypeType A HMA
HMA Grading1/2 inch Lot number
Sublot number HMA Design ID JMF3512-2019-144-320819_TEST_11/2019
Test Details
DIME Sample ID: 2019-11-15-16
DIME Test ID: 2019-11-15-16-5
Testing Lab: CT HQ - Hot Mix Asphalt Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2019-11-16
Test Results

Input Type: Calculated
Tester's full name: Clinton Edmiston
Date of test: 11/15/2019
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average:no data
Impression at specified number of passes average:no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A):21900
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B):21900
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A):12.7 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B):12.7 mm
Stripping Inflection Point (Wheel A):0
Stripping Inflection Point (Wheel B):0
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 11/16/2019