Summary for Test 2019-04-16-1-7
Test performed: ASTM E18-15Project Information
| Project Identifiers | DEA: No Project |
|---|---|
| DIST-CO-RTE-PM | --- |
| Award Date | Not set |
| Closeout Date | 11/01/2022 |
| Work Description | Special project identifier for material not associated with a project |
| Location Description | Not set |
| QA Service Level | NOT VERIFIED |
Sample Information
| Sample Taken Date | 04/16/2019 | Sample Unique Key | 1 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 04/26/2019 |
| Sample type | Verification | A brief description of the sample | 2" A563-DH HDG anchor assembly nuts |
| The quantity of what the sample constitutes | 5 | From where was the sample collected | Fabricator |
| First name of sampler or witnessed by | David | Last name of sampler or witnessed by | Flygare |
| Title of sampler | CT METS QA INSPECTOR | Telephone number of sampler | 8016692984 |
| Laboratory sample identification | Linked DIME Sample ID | ||
| The fabricator/manufacturer/facility name | UIS | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | B76-049-19 | Structure unique identifier | Not set |
| Structure name | Not set |
Material Information
| Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | none |
|---|---|---|---|
| Heat Number(s) | 188194 | Nut Mfg. Lot Number(s) | Dyson DDYO |
| Washer Mfg. Lot Number(s) | n/a | Bolt Specification | n/a |
| Bolt Length(s) | n/a | Nut Specification | A563-DH |
| Washer Specification | n/a | Finish | HDG |
| Diameter/Size | 2" | Bolt Mfg. Lot Number | n/a |
| Rocap Test Requirement(s) | none | Lubricant Requirements(s) | yes |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2019-04-16-1
DIME Test ID: 2019-04-16-1-7
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM E18-15: Standard Test Methods for Rockwell Hardness of Metallic Materials (Hardness)
Test Release Date: 2019-05-07
Test Results
Input Type: Calculated
Tester's full name: Steven Paine
Date of test: 04/29/2019
Sample No.: 1B
Rocap Number: no data
Heat Number(s): no data
Mfg. Lot Number: DDYO
Finish Coating: ASTM F2329 - Hot Dip
Product Markings: DH D/N 2H
Size: 2 in
Bolt Length: no data
Hardness Reading Scale: C Scale
Spacing: Ok
Hardness Reading Average: 28.53
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 4/30/2019 ✔