Summary for Test 2021-04-01-32-5
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 215062 DEA: 030F2904 EFIS: 0314000101 |
---|---|
DIST-CO-RTE-PM | 03-BUT-99-14.9/15.7 |
Award Date | 09/24/2020 |
Closeout Date | 03/02/2022 |
Work Description | CONSTRUCT BRIDGE AND ROADWAY; & REMOVE BRIDGE. |
Location Description | BUTTE COUNTY ABOUT 10 MILES NORTH OF GRIDLEY FROM 0.3 MILE SOUTH TO 0.5 MILE NORTH OF NELSON AVENUE |
QA Service Level | 1 (Verified on 07/20/2020) |
Sample Information
Sample Taken Date | 04/01/2021 | Sample Unique Key | 32 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 04/01/2021 |
Sample type | Verification | A brief description of the sample | 3/4" (Nominal Size) Untreated Virgin Aggregate |
The quantity of what the sample constitutes | JMF Verification | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Teichert Personnel (SAMPLER) | Last name of sampler or witnessed by | Brad McKeehan (WITNESS) |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | JMF21-020B | |
The fabricator/manufacturer/facility name | Teichert - Hallwood Plant | Transportation Laboratory (TL) Number | C706327 |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-58-0006::HALLWOOD PLANT |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Cold Feed | |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2021-04-01-32
DIME Test ID: 2021-04-01-32-5
Testing Lab: CT D03 - Olivehurst Northern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2021-06-02
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Kavon Rastegar
Date of test: 04/16/2021
Weighted percentage of particles (by mass) that were flat and elongated: 99 %
Weighted percentage of particles (by mass) that were not flat and elongated: 1 %
General comments (publicly viewable) (Max 1000 characters): JMF21-020B. Thomas Stinnett
Test was verified on 6/2/2021 ✔