Summary for Test 2019-09-16-16-5
Test performed: AASHTO T96-02r10
Warning: The test results shown on this page have been superseded and are invalid.
This information is for reference only.
Project Information
Project Identifiers | Project ID: 214122 DEA: 081G1204 |
---|---|
DIST-CO-RTE-PM | 08-RIV-243-13.3/29.7 |
Award Date | 06/12/2019 |
Closeout Date | 03/25/2020 |
Work Description | COLD PLANE AC, PLACE RHMA-G AND RECESSED THERMOPLASTIC TRAFFIC STRIPE. |
Location Description | RIVERSIDE COUNTY IN AND NEAR BANNING FROM 0.7 MILE NORTH OF BLACK MOUNTAIN TRAIL TO ROUTE 243/10 SEPARATION |
QA Service Level | 1 (Verified on 03/25/2020) |
Sample Information
Sample Taken Date | 09/16/2019 | Sample Unique Key | 16 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 09/25/2019 |
Sample type | Verification | A brief description of the sample | 3/4 RHMA-G-SP |
The quantity of what the sample constitutes | PSUE 6 bags | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Matich Cabazon | Last name of sampler or witnessed by | QC |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 0564G-19 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | Robertsons - Cabazon, Cemex - Lytle Creek | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-33-0008, 91-36-0040 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | 3/4 RHMA-G-SP | The fabricator/manufacturer designation for the sample | CHP-68E |
The plant number | Unknown | A detailed description of where the material sample was collected | Belt Cut at Matich Cabazon Plant |
Where the material sample would have been placed if not sampled | Unknown | Primary Aggregate Nominal Size | 3/4 inch |
The concrete mix design number | Unknown | Lot number | Unknown |
Sublot number | Unknown | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2019-09-16-16
DIME Test ID: 2019-09-16-16-5
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: AASHTO T96-02r10: Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (Los Angeles Rattler)
Test Release Date: 2019-10-07
Test Results
Input Type: Measured
Tester's full name: Husni Ankir
Date of test: 09/27/2019
Grading designation: B
Mass of sample (before test): 5000 grams
Mass of sample on No.12 sieve (after 100 revolutions): 4547 grams
Mass of sample on No.12 sieve (after 500 revolutions): 2880 grams
Percent loss after 100 revolutions: 9 %
Percent loss after 500 revolutions: 42 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 10/7/2019 ✔
Warning: The test results shown on this page have been superseded and are invalid.
This information is for reference only.