Summary for Test 2024-03-07-10-5
Test performed: ASTM F606-21Project Information
Project Identifiers | Project ID: 993131 DEA: 010A1104 EFIS: 0112000211 |
---|---|
DIST-CO-RTE-PM | 01-HUM-101-27.7 |
Award Date | 09/21/2021 |
Closeout Date | Not set |
Work Description | BRIDGE SEISMIC RETROFIT AND ROCK SLOPE PROTECTION. |
Location Description | HUMBOLDT COUNTY NEAR MYERS FLAT AT SOUTH FORK EEL RIVER BRIDGE |
QA Service Level | 1 (Verified on 07/22/2021) |
Sample Information
Sample Taken Date | 03/07/2024 | Sample Unique Key | 10 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 03/22/2024 |
Sample type | Quality Assurance | A brief description of the sample | High Strength Fastener Assemblies |
The quantity of what the sample constitutes | 250 | From where was the sample collected | Supplier |
First name of sampler or witnessed by | Chris | Last name of sampler or witnessed by | Dsouza |
Title of sampler | CT METS QA INSPECTOR | Telephone number of sampler | 9493852715 |
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | St Louis Screw and Bolt | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | L132-004-24 | Structure unique identifier | |
Structure name |
Material Information
Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | TT0176203 |
---|---|---|---|
Heat Number(s) | 10827380 | Nut Mfg. Lot Number(s) | W000090872 |
Washer Mfg. Lot Number(s) | 19395-210074 | Bolt Specification | ASTM A325 |
Bolt Length(s) | 7 | Nut Specification | ASTM A563 |
Washer Specification | ASTM F436 | Finish | MG |
Diameter/Size | 1-1/8 | Bolt Mfg. Lot Number | M5476 |
Rocap Test Requirement(s) | Lubricant Requirements(s) |
Test Details
DIME Sample ID: 2024-03-07-10
DIME Test ID: 2024-03-07-10-5
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM F606-21: Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets (Proof Load with Wedge)
Test Release Date: 2024-03-25
Test Results
Number of Bolt Samples: 1
Input Type: Measured
Tester's full name: aauvinen
Date of test: 03/20/2024
UTM: 450kip
Temperature: no data
Num | Sample | Bolt Mfg. Lot Number | Size (in) | Peak Load (lbf) | Peak Load (kN) | Wedge Angle (deg) | Comments | Tested By |
---|---|---|---|---|---|---|---|---|
1 | 1E | M5476 | 1.1250 | 109723 | 488.07 | 6.00 | Wedge Tensile | aauvinen |
General comments (publicly viewable) (Max 1000 characters): Wedge Tensile
Test Graph
Source: Bluehill Data Point FileTest was verified on 3/25/2024 ✔