Summary for Test 2023-11-10-5-1
Test performed: CTM 202-November 2011Project Information
Project Identifiers | Project ID: 215314 DEA: 07333004 EFIS: 0716000298 |
---|---|
DIST-CO-RTE-PM | 07-LA-5,5-15.1/22.9 |
Award Date | 10/20/2022 |
Closeout Date | Not set |
Work Description | PROJECT PILOT 1 |
Location Description | LOS ANGELES COUNTY IN AND NEAR LOS ANGELES ON ROUTE 5 FROM 0.1 MILE SOUTH OF CALZONA STREET TO 0.1 MILE SOUTH OF RIVERSIDE DRIVE AND ROUTE 2 AT LOS ANGELES REGIONAL TRANSPORTATION MANAGEMENT CENTER |
QA Service Level | 1 (Verified on 07/12/2021) |
Sample Information
Sample Taken Date | 11/10/2023 | Sample Unique Key | 5 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 11/10/2023 |
Sample type | Department Acceptance | A brief description of the sample | 3/8 x No. 8 PCC Aggregate |
The quantity of what the sample constitutes | 90+ CY | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Honesto | Last name of sampler or witnessed by | Castillo |
Title of sampler | MREAS | Telephone number of sampler | 12134537563 |
Laboratory sample identification | 52B | Linked DIME Sample ID | 2023-11-10-4 & 2023-11-10-6 |
The fabricator/manufacturer/facility name | National Ready Mix Concrete-Vernon | Transportation Laboratory (TL) Number | C006728 |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-19-0052 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | 144 | A detailed description of where the material sample was collected | Belt Cut at Plant |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/8 inch | |
The concrete mix design number | S73C445T15 | Lot number | |
Sublot number | Aggregate Mix Number |
Test Details
DIME Sample ID: 2023-11-10-5
DIME Test ID: 2023-11-10-5-1
Testing Lab: CT D07 - Plant Services
Test Method: CTM 202-November 2011: Method of Test for Sieve Analysis of Fine and Coarse Aggregates
Test Release Date: 2023-11-14
Test Results
What size aggregate is being tested?: 0.375 in x No. 8 - Coarse Aggregate
Individual or cumulative mass retained on each sieve?: Cumulative Mass Retained
For Combined Gradation only, has the fine aggregate sample been reduced?: No
For Combined Gradation only, use #40 Sieve?: No
Input Type: Calculated
Tester's full name: Honesto Castillo
Date of test: 11/10/2023
Cumulative percent passing the 1/2 in. sieve: 100 %
Cumulative percent passing the 3/8 in. sieve: 94 %
Cumulative percent passing the #4 sieve: 28 %
Cumulative percent passing the #8 sieve: 13 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 11/14/2023 ✔