DIME - Test Summary

Summary for Test 2023-01-26-35-4

Test performed: ASTM C128-12

Project Identifiers	Project ID: 994358 DEA: 033J3304 EFIS: 0322000251
DIST-CO-RTE-PM	03-SAC/SAC-12-0/0.5
Award Date	Not set
Closeout Date	Not set
Work Description	Replace backup drive system, replace lift span deck, install hydraulic barrier system and new generator, replace electrical control system, install new traffic gates and elevators, traffic control,
Location Description	Not set
QA Service Level	1 (Verified on 10/25/2022)

Sample Taken Date	01/26/2023	Sample Unique Key	35
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	01/27/2023
Sample type	Per Request	A brief description of the sample	lightweight Sand
The quantity of what the sample constitutes	1-5 gallon bucket	From where was the sample collected	Source
First name of sampler or witnessed by	Rusty	Last name of sampler or witnessed by	D'Anna
Title of sampler	SR	Telephone number of sampler
Laboratory sample identification	23-LWF-0007	Linked DIME Sample ID
The fabricator/manufacturer/facility name	na	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	0000
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	Volumetric Truck
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	fine
The concrete mix design number		Lot number
Sublot number		Aggregate Mix Number

DIME Sample ID: 2023-01-26-35

DIME Test ID: 2023-01-26-35-4

Testing Lab: CT HQ - Sacramento Aggregate Testing Laboratory

Test Method: ASTM C128-12: Standard Test Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate

Test Release Date: 2023-02-03

What procedure was used?: Gravimetric Procedure

Basis for testing: Saturated Surface Dry

Input Type: Measured

Tester's full name: Bang Nguyen

Date of test: 02/03/2023

Mass of saturated surface dry sample: 250.3 grams

Mass of pycnometer, sample and water: 778.5 grams

Mass of pycnometer and water: 662.2 grams

Mass of oven dried sample: 220.2 grams

Specific Gravity: 1.87

Density: 1860 kg/m^3

Absorption: 13.67 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 2/3/2023 ✔