Summary for Test 2023-01-26-35-3
Test performed: ASTM C128-12Project Information
Project Identifiers | Project ID: 994358 DEA: 033J3304 EFIS: 0322000251 |
---|---|
DIST-CO-RTE-PM | 03-SAC/SAC-12-0/0.5 |
Award Date | Not set |
Closeout Date | Not set |
Work Description | Replace backup drive system, replace lift span deck, install hydraulic barrier system and new generator, replace electrical control system, install new traffic gates and elevators, traffic control, |
Location Description | Not set |
QA Service Level | 1 (Verified on 10/25/2022) |
Sample Information
Sample Taken Date | 01/26/2023 | Sample Unique Key | 35 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 01/27/2023 |
Sample type | Per Request | A brief description of the sample | lightweight Sand |
The quantity of what the sample constitutes | 1-5 gallon bucket | From where was the sample collected | Source |
First name of sampler or witnessed by | Rusty | Last name of sampler or witnessed by | D'Anna |
Title of sampler | SR | Telephone number of sampler | |
Laboratory sample identification | 23-LWF-0007 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | na | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 0000 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Volumetric Truck | |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | fine | |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number |
Test Details
DIME Sample ID: 2023-01-26-35
DIME Test ID: 2023-01-26-35-3
Testing Lab: CT HQ - Sacramento Aggregate Testing Laboratory
Test Method: ASTM C128-12: Standard Test Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate
Test Release Date: 2023-02-03
Test Results
What procedure was used?: Gravimetric Procedure
Basis for testing: Oven Dry
Input Type: Measured
Tester's full name: Bang Nguyen
Date of test: 02/03/2023
Mass of saturated surface dry sample: 250.3 grams
Mass of pycnometer, sample and water: 778.5 grams
Mass of pycnometer and water: 662.2 grams
Mass of oven dried sample: 220.2 grams
Specific Gravity: 1.64
Density: 1640 kg/m^3
Absorption: 13.67 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 2/3/2023 ✔