Summary for Test 2022-08-15-43-8
Test performed: ASTM D4791-10Project Information
| Project Identifiers | Project ID: 993652 DEA: 112N1454 |
|---|---|
| DIST-CO-RTE-PM | 11-SD-905-3.8/R11.5 |
| Award Date | 06/10/2022 |
| Closeout Date | 09/14/2023 |
| Work Description | APPLY MICROSURFACING, REMOVE AND PLACE PAVEMENT DELINEATION. |
| Location Description | SAN DIEGO COUNTY IN AND NEAR OTAY MESA FROM 0.6 MILE EAST OF JUNCTION ROUTE 5 TO 0.2 MILE NORTH OF MEXICO BORDER |
| QA Service Level | 1 (Verified on 03/29/2022) |
Sample Information
| Sample Taken Date | 08/15/2022 | Sample Unique Key | 43 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 08/29/2022 |
| Sample type | Verification | A brief description of the sample | PSUE 1/2" HMA-A-SP R15 No LAS |
| The quantity of what the sample constitutes | 2 Bags Agg., 2 Bags Rap | From where was the sample collected | Manufacturer |
| First name of sampler or witnessed by | Vulcan | Last name of sampler or witnessed by | QC |
| Title of sampler | Telephone number of sampler | ||
| Laboratory sample identification | 0594A-22 | Linked DIME Sample ID | |
| The fabricator/manufacturer/facility name | Vulcan Otay | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-37-0035 |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | 320819 OTAY VAL | A detailed description of where the material sample was collected | Belt Cut at Vulcan Otay |
| Where the material sample would have been placed if not sampled | Asphalt Paving | Primary Aggregate Nominal Size | 1/2 inch |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2022-08-15-43
DIME Test ID: 2022-08-15-43-8
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2022-10-05
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 09/01/2022
Weighted percentage of particles (by mass) that were flat and elongated: 4 %
Weighted percentage of particles (by mass) that were not flat and elongated: 96 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 10/5/2022 ✔