Summary for Test 2021-11-03-48-6
Test performed: CTM 229-June 2011Project Information
| Project Identifiers | Project ID: 215360 DEA: 112N0454 EFIS: 1118000198 |
|---|---|
| DIST-CO-RTE-PM | 11-SD-94-30.0/39.0 |
| Award Date | 02/18/2021 |
| Closeout Date | 08/02/2022 |
| Work Description | PLACING CHIP SEAL, SLURRY SEAL, SHOULDER BACKING AND STRIPING. |
| Location Description | SAN DIEGO COUNTY NEAR DULZURA AND BARRETT JUNCTION FROM 0.9 MILE EAST OF GRANDE CREEK BRIDGE TO ROUTE 188. |
| QA Service Level | 1 (Verified on 02/08/2021) |
Sample Information
| Sample Taken Date | 11/03/2021 | Sample Unique Key | 48 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 11/26/2021 |
| Sample type | Quality Assurance | A brief description of the sample | Slurry type III |
| The quantity of what the sample constitutes | 2 Bags | From where was the sample collected | Source |
| First name of sampler or witnessed by | Not Provided | Last name of sampler or witnessed by | Not Provided |
| Title of sampler | Telephone number of sampler | ||
| Laboratory sample identification | Linked DIME Sample ID | ||
| The fabricator/manufacturer/facility name | Not Provided | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | Not Provided |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | A detailed description of where the material sample was collected | Slurry Type III | |
| Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/8 inch | |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2021-11-03-48
DIME Test ID: 2021-11-03-48-6
Testing Lab: CT D11 - District 11 Materials Laboratory
Test Method: CTM 229-June 2011: Method of Test for Durability Index
Test Release Date: 2022-01-13
Test Results
What test(s) are being run?: Fine durability only
Input Type: Measured
Tester's full name: Daniel Smith
Date of test: 01/04/2022
Clay reading: 4.5
Sand reading: 3.7
Fine durability index: 82
General comments (publicly viewable) (Max 1000 characters): Pass
Test was verified on 1/13/2022 ✔