Summary for Test 2021-11-03-48-3
Test performed: AASHTO T335-09r13Project Information
Project Identifiers | Project ID: 215360 DEA: 112N0454 EFIS: 1118000198 |
---|---|
DIST-CO-RTE-PM | 11-SD-94-30.0/39.0 |
Award Date | 02/18/2021 |
Closeout Date | 08/02/2022 |
Work Description | PLACING CHIP SEAL, SLURRY SEAL, SHOULDER BACKING AND STRIPING. |
Location Description | SAN DIEGO COUNTY NEAR DULZURA AND BARRETT JUNCTION FROM 0.9 MILE EAST OF GRANDE CREEK BRIDGE TO ROUTE 188. |
QA Service Level | 1 (Verified on 02/08/2021) |
Sample Information
Sample Taken Date | 11/03/2021 | Sample Unique Key | 48 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 11/26/2021 |
Sample type | Quality Assurance | A brief description of the sample | Slurry type III |
The quantity of what the sample constitutes | 2 Bags | From where was the sample collected | Source |
First name of sampler or witnessed by | Not Provided | Last name of sampler or witnessed by | Not Provided |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | Not Provided | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | Not Provided |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Slurry Type III | |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/8 inch | |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2021-11-03-48
DIME Test ID: 2021-11-03-48-3
Testing Lab: CT D11 - District 11 Materials Laboratory
Test Method: AASHTO T335-09r13: Standard Method of Test for Determining the Percentage of Fracture in Coarse Aggregate (Percent of Crushed Particles)
Test Release Date: 2022-01-13
Test Results
Method: 2 - Individual Fracture Determination
Aggregate Size and Fracture Type: Coarse 1 and 2 Faced and Fine 1 Faced
Input Type: Calculated
Tester's full name: Daniel Smith
Date of test: 01/11/2022
Weighted average percentage of fractured, coarse, 2 faced particles: 99.5 %
Weighted average percentage of fractured, coarse, 1 faced particles: 99.5 %
Percentage of fractured, fine, 1 faced particles tested: 100 %
General comments (publicly viewable) (Max 1000 characters): Pass
Test was verified on 1/13/2022 ✔