Summary for Test 2021-09-16-31-8

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 215587
DEA: 081L6804
EFIS: 0820000138
DIST-CO-RTE-PM08-RIV-91,15-7.5/13.4,8.2/23.9
Award Date04/30/2021
Closeout DateNot set
Work DescriptionSLAB REPLACEMENT, PLACE SLURRY SEAL AND REPLACE AC SURFACING.
Location DescriptionRIVERSIDE COUNTY IN AND NEAR CORONA AND MURRIETA ON ROUTE 91 FROM ROUTE 15/91 SEPARATION TO 0.4 MILE EAST OF TYLER STREET AND ON ROUTE 15 FROM 1.5 MILES NORTH OF WINCHESTER ROAD TO NICHOLS ROAD
QA Service Level1 (Verified on 06/23/2021)

Sample Information

Sample Taken Date09/16/2021 Sample Unique Key31
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing09/28/2021
Sample typeVerification A brief description of the sampleJMF 3/4" WMA-A-SP R15 0.4% EVO
The quantity of what the sample constitutes4 Bags Combined Agg., 2 Bags Rap From where was the sample collectedManufacturer
First name of sampler or witnessed byRMA Last name of sampler or witnessed byQC
Title of sampler Telephone number of sampler
Laboratory sample identification0554A-21 Linked DIME Sample ID
The fabricator/manufacturer/facility nameAll American Asphalt Corona Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA or name of Pit)91-33-0005
The fabricator's/manufacturer's product name for the sample3/4 WMA-A-SP R15 The fabricator/manufacturer designation for the sample
The plant number103793 A detailed description of where the material sample was collectedBelt Cut at All American Asphalt Corona Plant
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size3/4 inch
The concrete mix design number Lot number
Sublot number Aggregate Mix NumberNot set

Test Details

DIME Sample ID: 2021-09-16-31
DIME Test ID: 2021-09-16-31-8
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2021-10-06

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 10/05/2021
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 10/6/2021