DIME - Test Summary

Summary for Test 2020-08-17-8-4

Test performed: AASHTO T84-14

Project Identifiers	Project ID: 213999 DEA: 07313604 EFIS: 0715000092
DIST-CO-RTE-PM	07-LA-5-R70.4
Award Date	10/25/2019
Closeout Date	01/28/2021
Work Description	REMOVE AND REPLACE REINFORCED CONCRETE PIPE.
Location Description	LOS ANGELES COUNTY AT 4.4 MILES NORTH OF TEMPLIN HIGHWAY
QA Service Level	1 (Verified on 05/13/2020)

Sample Taken Date	08/17/2020	Sample Unique Key	8
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	08/19/2020
Sample type	Verification	A brief description of the sample	PSUE 3/4" WMA-A-SP R15 0.25% WMA
The quantity of what the sample constitutes	5 Bags Of Agg., 1 Bag Of Rap	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	Michael	Last name of sampler or witnessed by	Brook
Title of sampler		Telephone number of sampler
Laboratory sample identification	0509A-20	Linked DIME Sample ID
The fabricator/manufacturer/facility name	Vulcan- Sun Valley	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-19-0017-, 91-19-0019, 91-19-0021
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number	220826 SVA SJR	A detailed description of where the material sample was collected	Belt Cut at Vulcan Sun Valley Plant
Where the material sample would have been placed if not sampled	Asphalt Paving	Primary Aggregate Nominal Size	3/4 inch
The concrete mix design number		Lot number
Sublot number		Aggregate Mix Number	Not set

DIME Sample ID: 2020-08-17-8

DIME Test ID: 2020-08-17-8-4

Testing Lab: CT D08 - Fontana Southern Regional Laboratory

Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)

Test Release Date: 2020-08-28

Input Type: Measured

Tester's full name: Danilo Ferrer

Date of test: 08/21/2020

Mass of saturated surface dry sample (before pycnometer) (S): 500 grams

Mass of the pycnometer with water and aggregate (C): 970.5 grams

Mass of the pycnometer with water (B): 655.8 grams

Mass of the oven dried sample (before pycnometer) (A): 496.7 grams

Mass of the saturated surface dry aggregate (for absorption) (S): 500 grams

Mass of the oven dry aggregate (for absorption) (A): 496.7 grams

Test Sample Preparation: Total Saturation

Bulk specific gravity: 2.681

Bulk specific gravity (SSD Basis): 2.698

Apparent specific gravity: 2.729

Absorption: 0.7 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 8/28/2020 ✔