Test 2020-01-01-11-5 (AASHTO T324-14) Summary
Project Information
| Project Identifiers | Project ID: 213943 DEA: 051G5704 EFIS: 0515000049 | ||
|---|---|---|---|
| DIST-CO-RTE-PM | 05-SLO-58-0.7/1.9 | ||
| Work Description | COLD PLANE AC, PLACE RHMA-G AND RECONSTRUCT CURB RAMPS. | ||
| Location Description | SAN LUIS OBISPO COUNTY AT SANTA MARGARITA FROM 0.7 MILE EAST OF ROUTE 101/58 SEPARATION TO J STREET | ||
Sample Information
| Sample Taken Date | 1/1/2020 | Sample Unique Key | 11 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | No | Date that the sample was received by the laboratory/organization performing the testing | Not set |
| Sample type | Quality Control | A brief description of the sample | RHMA-G |
| The quantity of what the sample constitutes | 0 | From where was the sample collected | Other |
| First name of sampler or witnessed by | Mr | Last name of sampler or witnessed by | witness |
| Title of sampler | Laboratory sample identification | ||
| The fabricator/manufacturer/facility name | CalPortland Paso Robles | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name |
Material Information
| Material Type | Hot Mix Asphalt | HMA Type | RHMA-G |
|---|---|---|---|
| HMA Grading | 1/2 inch | Lot number | |
| Sublot number | HMA Design ID | JMF3512-2020-156-G2214H830 |
Test Details
DIME Sample ID: 2020-01-01-11
DIME Test ID: 2020-01-01-11-5
Testing Lab: CT D05 - Field Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2020-01-17
Test Results
Input Type: Calculated
Tester's full name: Daniel Gingras
Date of test: 01/01/2020
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average:no data
Impression at specified number of passes average:no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A):15000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B):15000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A):4.6 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B):4.6 mm
Stripping Inflection Point (Wheel A):>25000
Stripping Inflection Point (Wheel B):>25000
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 01/17/2020 ✔