DIME - Test Summary

Summary for Test 2020-06-11-55-2

Test performed: AASHTO T104-99r16

Project Identifiers	Project ID: 213887 DEA: 024H2604 EFIS: 0218000100
DIST-CO-RTE-PM	02-SIS-97-R11.5/17.1
Award Date	03/15/2019
Closeout Date	01/04/2021
Work Description	COLD PLANE AC, REPLACE AC SURFACING, PLACE AC, RUMBLE STRIP & STRIPE.
Location Description	SISKIYOU COUNTY ABOUT 12 MILES NORTH OF WEED FROM YELLOW BUTTE ROAD TO 0.6 MILE NORTH OF DEER MOUNTAIN ROAD
QA Service Level	1 (Verified on 04/03/2019)

Sample Taken Date	06/11/2020	Sample Unique Key	55
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	06/11/2020
Sample type	Verification	A brief description of the sample	3/8 inch Sized Untreated Virgin Aggregate
The quantity of what the sample constitutes	JMF	From where was the sample collected	Source
First name of sampler or witnessed by	Ashton	Last name of sampler or witnessed by	Erickson
Title of sampler	RMC QC	Telephone number of sampler
Laboratory sample identification	D78473B	Linked DIME Sample ID
The fabricator/manufacturer/facility name	Truax Quarry	Transportation Laboratory (TL) Number	990768
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-47-0037
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	Sized Untreated Aggregate Stockpile
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/8 inch
The concrete mix design number	JMF 19-24-S3	Lot number
Sublot number		Aggregate Mix Number	Not set

DIME Sample ID: 2020-06-11-55

DIME Test ID: 2020-06-11-55-2

Testing Lab: CT HQ - Sacramento Aggregate Testing Laboratory

Test Method: AASHTO T104-99r16: Standard Method of Test for Soundness of Aggregate by Use of Sodium Sulfate or Magnesium Sulfate (Soundness)

Test Release Date: 2020-10-07

Percentage of the total sample represented by each size

Size of aggregate being tested: Coarse Aggregate

What type of solution was used?: Sodium sulfate

What was the condition of the solution?: Freshly prepared

Number of immersion cycles performed: 5

Input Type: Calculated

Tester's full name: Jay Horton

Date of test: 10/07/2020

Percentage of 2 ½ x 1 ½ material loss: 0 %

Percentage of 1 ½ x ¾ inch material loss: 0 %

Percentage of ¾ x ⅜ inch material loss: 0 %

Percentage of ⅜ inch x No. 4 material loss: 9.2 %

Coarse weighted average loss: 5.9 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 10/7/2020 ✔