Summary for Test 2018-05-15-37-10
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 212679 DEA: 023E7204 EFIS: 0200020154 |
---|---|
DIST-CO-RTE-PM | 02-TEH-36-42.1/46.0 |
Award Date | 12/18/2017 |
Closeout Date | 08/07/2019 |
Work Description | COLD PLANING, PAVING, MINOR CONCRETE, ELECTRICAL AND STRIPING WORK. |
Location Description | TEHAMA COUNTY IN AND NEAR RED BLUFF FROM EAST SAND SLOUGH BRIDGE TO 0.6 MILE EAST OF STICE ROAD |
QA Service Level | 1 (Verified on 05/24/2018) |
Sample Information
Sample Taken Date | 05/15/2018 | Sample Unique Key | 37 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 05/15/2018 |
Sample type | Verification | A brief description of the sample | 3/4-inch Type G Aggregate |
The quantity of what the sample constitutes | JMF Verification | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Cheryl | Last name of sampler or witnessed by | Abraham |
Title of sampler | TET | Telephone number of sampler | Unknown |
Laboratory sample identification | D77386 | Linked DIME Sample ID | Unknown |
The fabricator/manufacturer/facility name | Tullis, Inc - Northstate Asphalt - Redding, CA | Transportation Laboratory (TL) Number | 894975 |
Inspector Lot Number from the Transportation Laboratory (TL) Form | 18-09-S1 | Structure unique identifier | Not set |
Structure name | Not set |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-45-0057::SHASTA RANCH AGGREGATES |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | Unknown | The fabricator/manufacturer designation for the sample | Unknown |
The plant number | Unknown | A detailed description of where the material sample was collected | Samplimg Device at Plant |
Where the material sample would have been placed if not sampled | Unknown | Primary Aggregate Nominal Size | 3/4 inch |
The concrete mix design number | L180371 | Lot number | Not set |
Sublot number | Not set | Aggregate Mix Number | Not set |
HMA Pay | No |
Test Details
DIME Sample ID: 2018-05-15-37
DIME Test ID: 2018-05-15-37-10
Testing Lab: CT D02 - Redding Northern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2018-08-14
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 1:5
Input Type: Calculated
Tester's full name: Mike Cruz
Date of test: 05/15/2018
Weighted percentage of particles (by mass) that were flat and elongated: 2 %
Weighted percentage of particles (by mass) that were not flat and elongated: 98 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 8/14/2018 ✔