Summary for Test 2026-08-26-22-5
Test performed: CTM 205-December 2010Project Information
| Project Identifiers | Project ID: 1002228 DEA: 051R7604 EFIS: 0524000115 |
|---|---|
| DIST-CO-RTE-PM | 05-SLO-229-5.5/9.2 |
| Award Date | Not set |
| Closeout Date | Not set |
| Work Description | RHMA-G overlay, asphalt rubber binder chip seal, & shoulder backing |
| Location Description | Not set |
| QA Service Level | 1 (Verified on 05/01/2026) |
Sample Information
| Sample Taken Date | 08/26/2026 | Sample Unique Key | 22 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | No | Date that the sample was received by the laboratory/organization performing the testing | 08/26/2026 |
| Sample type | Acceptance | A brief description of the sample | Shoulder Backing Aggregate |
| The quantity of what the sample constitutes | ? | From where was the sample collected | Job Site |
| First name of sampler or witnessed by | Kyle | Last name of sampler or witnessed by | Engen |
| Title of sampler | QA Tester | Telephone number of sampler | |
| Laboratory sample identification | 260826-1 Shoulder Backing | Linked DIME Sample ID | |
| The fabricator/manufacturer/facility name | Calportland - Rockey Canyon | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name | Bid Item | Not set |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-40-0013 |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | A detailed description of where the material sample was collected | Conveyor Belt | |
| Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2026-08-26-22
DIME Test ID: 2026-08-26-22-5
Testing Lab: CT D05 - Paso Robles Field Laboratory
Test Method: CTM 205-December 2010: Method of Test for Determining Percentage of Crushed Particles
Test Release Date: 2026-08-27
Test Results
Will you be using 1/4 in. x No. 4 sieve?: No
Input Type: Calculated
Tester's full name: Kyle Engen
Date of test: 08/27/2026
Percent Coarse Crushed: 74 %
Percent Fine Crushed: 0 %
General comments (publicly viewable) (Max 1000 characters): 50 Spec 2-Face
Test was verified on 8/27/2026 ✔