DIME - Test Summary

Summary for Test 2026-03-17-19-2

Test performed: AASHTO T30-25

Project Identifiers	Project ID: 1001468 DEA: 081L2404 EFIS: 0819000167
DIST-CO-RTE-PM	08-SBD-95-R57.2/64.5
Award Date	Not set
Closeout Date	Not set
Work Description	RHMA (GAP GRADED), REPLACE AC SURFACING, AND COLD PLANE AC PVMT.
Location Description	SAN BERNARDINO COUNTY NEAR NEEDLES FROM ROUTE 40/95 SEPARATION TO 0.5 MILE NORTH OF GOFFS ROAD
QA Service Level	1 (Verified on 08/29/2025)

Sample Taken Date	03/17/2026	Sample Unique Key	19
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	03/17/2026
Sample type	Acceptance	A brief description of the sample	3/4" 1 bag comb aggregate
The quantity of what the sample constitutes	660 Tons	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	Francisco	Last name of sampler or witnessed by	Ruvalcaba
Title of sampler		Telephone number of sampler
Laboratory sample identification		Linked DIME Sample ID
The fabricator/manufacturer/facility name	Blue Diamond-Victorville	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name		Bid Item	Not set

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-36-0046, 91-36-0022
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	Belt
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/4 inch
The concrete mix design number		Lot number
Sublot number		Aggregate Mix Number	300154 R25

DIME Sample ID: 2026-03-17-19

DIME Test ID: 2026-03-17-19-2

Testing Lab: CT D08 - Barstow Field Laboratory 1

Test Method: AASHTO T30-25: Standard Method of Test for Mechanical Analysis of Extracted Aggregate (Mechanical Analysis)

Test Release Date: 2026-03-24

Individual or cumulative mass retained on each sieve?: Individual

Has the fine aggregate sample been reduced?: No

Is an aggregate correction factor used?: Yes

Was the aggregate obtained using ASTM D8159?: No

Input Type: Calculated

Tester's full name: Julius Esonwune

Date of test: 03/21/2026

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 3/24/2026 ✔