DIME - Test Summary

Summary for Test 2025-08-21-136-2

Test performed: AASHTO T30-25

Project Identifiers	Project ID: 1000602 DEA: 040K6404 EFIS: 0416000112
DIST-CO-RTE-PM	04-SOL-80-15.9/30.2
Award Date	12/17/2024
Closeout Date	Not set
Work Description	COLD PLANE, OVERLAY, MGS, RAMP METERING, LIGHTING AND SIGNAL.
Location Description	SOLANO COUNTY ON ROUTE 80 IN AND NEAR FAIRFIELD AND VACAVILLE AT VARIOUS LOCATIONS FROM 1.5 MILES EAST OF SUISUN VALLEY ROAD OVERCROSSING TO 0.8 MILE EAST OF LEISURE TOWN ROAD OVERCROSSING.
QA Service Level	1 (Verified on 10/07/2024)

Sample Taken Date	08/21/2025	Sample Unique Key	136
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	08/22/2025
Sample type	Quality Assurance	A brief description of the sample	3/4
The quantity of what the sample constitutes	750 Tons	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	Christian	Last name of sampler or witnessed by	Sousa
Title of sampler		Telephone number of sampler
Laboratory sample identification		Linked DIME Sample ID
The fabricator/manufacturer/facility name	Teichert Woodland	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name		Bid Item	Not set

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-57-0004
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	At the plant
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/4 inch
The concrete mix design number		Lot number	2
Sublot number	2	Aggregate Mix Number

DIME Sample ID: 2025-08-21-136

DIME Test ID: 2025-08-21-136-2

Testing Lab: CT D04 - Concord Field Laboratory

Test Method: AASHTO T30-25: Standard Method of Test for Mechanical Analysis of Extracted Aggregate (Mechanical Analysis)

Test Release Date: 2026-02-20

Individual or cumulative mass retained on each sieve?: Cumulative

Has the fine aggregate sample been reduced?: No

Is an aggregate correction factor used?: No

Was the aggregate obtained using ASTM D8159?: No

Input Type: Calculated

Tester's full name: Henry Concepcion

Date of test: 08/22/2025

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 2/20/2026 ✔