DIME - Test Summary

Summary for Test 2024-06-10-99-3

Test performed: CTM 212-May 2010

Project Identifiers	Project ID: 995054 DEA: 024H0204 EFIS: 0218000069
DIST-CO-RTE-PM	02-TEH-36-20.0/39.7
Award Date	10/23/2023
Closeout Date	07/03/2025
Work Description	PLACE RHMA AND HMA, CORRECT SEGMENTS, AND REPLACE AC SURFACING.
Location Description	TEHAMA COUNTY NEAR RED BLUFF FROM 0.8 MILE EAST OF SALT CREEK BRIDGE TO BAKER ROAD
QA Service Level	1 (Verified on 08/14/2023)

Sample Taken Date	06/10/2024	Sample Unique Key	99
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	06/10/2024
Sample type	Acceptance	A brief description of the sample	2 bags of Shoulder Backing
The quantity of what the sample constitutes	2 Bags	From where was the sample collected	Source
First name of sampler or witnessed by	Cindy	Last name of sampler or witnessed by	Bryant
Title of sampler	TET	Telephone number of sampler
Laboratory sample identification	D79575	Linked DIME Sample ID
The fabricator/manufacturer/facility name	Tullis – Crystal Creek Aggregates (Redding, CA)	Transportation Laboratory (TL) Number	876862
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name		Bid Item	Not set

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-45-0021
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	Stockpile
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	1-1/2 inch
The concrete mix design number		Lot number
Sublot number		Aggregate Mix Number

DIME Sample ID: 2024-06-10-99

DIME Test ID: 2024-06-10-99-3

Testing Lab: CT D02 - Redding Northern Regional Laboratory

Test Method: CTM 212-May 2010: Method of Test for Unit Weight of Aggregate

Test Release Date: 2024-06-27

Input Type: Measured

Tester's full name: Joe Mishoe

Date of test: 06/25/2024

Which procedure was used to fill the measure with aggregate?: no data

Weight of water in the measure: 21.06 lbm

Water temperature: 73 deg F

Tare weight of empty measure: 12.9 lbm

Weight of measure filled with aggregate (test 1): 51.1 lbm

Weight of measure filled with aggregate (test 2): 51.2 lbm

Weight of measure filled with aggregate (test 3): 51.6 lbm

Water density: 62.28 lbf/ft^3

Factor F: 2.96 ft^-3

Net weight of aggregate in measure (test 1): 38.2 lbm

Net weight of aggregate in measure (test 2): 38.3 lbm

Net weight of aggregate in measure (test 3): 38.7 lbm

Average net weight of aggregate required to fill the measure: 38.4 lbm

Aggregate unit weight: 113.55 lbf/ft^3

General comments (publicly viewable) (Max 1000 characters): UW=113.55 lbf/ft^3

Test was verified on 6/27/2024 ✔