DIME - Test Summary

Summary for Test 2024-03-28-45-2

Test performed: AASHTO T11-5

Project Identifiers	Project ID: 215314 DEA: 07333004 EFIS: 0716000298
DIST-CO-RTE-PM	07-LA-5,5-15.1/22.9
Award Date	10/20/2022
Closeout Date	Not set
Work Description	PROJECT PILOT 1
Location Description	LOS ANGELES COUNTY IN AND NEAR LOS ANGELES ON ROUTE 5 FROM 0.1 MILE SOUTH OF CALZONA STREET TO 0.1 MILE SOUTH OF RIVERSIDE DRIVE AND ROUTE 2 AT LOS ANGELES REGIONAL TRANSPORTATION MANAGEMENT CENTER
QA Service Level	1 (Verified on 07/12/2021)

Sample Taken Date	03/28/2024	Sample Unique Key	45
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	04/09/2024
Sample type	Department Acceptance	A brief description of the sample	3/4 HMA-A
The quantity of what the sample constitutes	400 tons	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	victor	Last name of sampler or witnessed by	Pham
Title of sampler		Telephone number of sampler	2137924794
Laboratory sample identification		Linked DIME Sample ID
The fabricator/manufacturer/facility name	All American Asphalt-Irwindale	Transportation Laboratory (TL) Number	0328B1
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-33-0005
The fabricator's/manufacturer's product name for the sample	3/4 HMA-A	The fabricator/manufacturer designation for the sample	mix 105793
The plant number	Irwindale	A detailed description of where the material sample was collected	Conveyor Belt
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/4 inch
The concrete mix design number	105793	Lot number
Sublot number		Aggregate Mix Number

DIME Sample ID: 2024-03-28-45

DIME Test ID: 2024-03-28-45-2

Testing Lab: CT D07 - Plant Services

Test Method: AASHTO T11-5: Standard Method of Test for Materials Finer Than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing

Test Release Date: 2024-04-18

Input Type: Calculated

Tester's full name: A.Truong

Date of test: 04/10/2024

Which test procedure is being used: Method A

Percent of sample passing the #200 sieve (by mass): 11.2 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 4/18/2024 ✔