DIME - Test Summary

Summary for Test 2024-03-15-5-1

Test performed: CTM 202-November 2011

Project Identifiers	Project ID: 215314 DEA: 07333004 EFIS: 0716000298
DIST-CO-RTE-PM	07-LA-5,5-15.1/22.9
Award Date	10/20/2022
Closeout Date	08/20/2025
Work Description	PROJECT PILOT 1
Location Description	LOS ANGELES COUNTY IN AND NEAR LOS ANGELES ON ROUTE 5 FROM 0.1 MILE SOUTH OF CALZONA STREET TO 0.1 MILE SOUTH OF RIVERSIDE DRIVE AND ROUTE 2 AT LOS ANGELES REGIONAL TRANSPORTATION MANAGEMENT CENTER
QA Service Level	1 (Verified on 07/12/2021)

Sample Taken Date	03/15/2024	Sample Unique Key	5
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	03/15/2024
Sample type	Department Acceptance	A brief description of the sample	3/8 x No. 8 PCC Aggregate
The quantity of what the sample constitutes	80 CY	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	Honesto	Last name of sampler or witnessed by	Castillo
Title of sampler	MREAS	Telephone number of sampler	12134537563
Laboratory sample identification	014B	Linked DIME Sample ID	2024-03-15-4 & 2024-03-15-6
The fabricator/manufacturer/facility name	Cemex Ready Mix Concrete-Los Angeles	Transportation Laboratory (TL) Number	C 006777
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name		Bid Item	Not set

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-36-0106
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number	4479A	A detailed description of where the material sample was collected	Plant Stockpile
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/8 inch
The concrete mix design number	1625995	Lot number
Sublot number		Aggregate Mix Number

DIME Sample ID: 2024-03-15-5

DIME Test ID: 2024-03-15-5-1

Testing Lab: CT D07 - Plant Services

Test Method: CTM 202-November 2011: Method of Test for Sieve Analysis of Fine and Coarse Aggregates

Test Release Date: 2024-03-27

What size aggregate is being tested?: 0.375 in x No. 8 - Coarse Aggregate

Individual or cumulative mass retained on each sieve?: Cumulative Mass Retained

For Combined Gradation only, has the fine aggregate sample been reduced?: No

For Combined Gradation only, use #40 Sieve?: No

Input Type: Calculated

Tester's full name: Honesto Castillo

Date of test: 03/15/2024

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 3/27/2024 ✔