Summary for Test 2023-12-12-30-8
Test performed: AASHTO T304-11Project Information
Project Identifiers | Project ID: 994102 DEA: 11430644 EFIS: 1119000045 |
---|---|
DIST-CO-RTE-PM | 11-SD-905-12.0 |
Award Date | 10/28/2022 |
Closeout Date | Not set |
Work Description | CONSTRUCT WEIGH-IN-MOTION FACILITY, CRCP, HMA, AND RETAINING WALL. |
Location Description | SAN DIEGO COUNTY NEAR SAN DIEGO AT OTAY MESA COMMERCIAL VEHICLE ENFORCEMENT FACILITY |
QA Service Level | 1 (Verified on 08/24/2022) |
Sample Information
Sample Taken Date | 12/12/2023 | Sample Unique Key | 30 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 12/13/2023 |
Sample type | Quality Assurance | A brief description of the sample | 3/4" HMA PSU |
The quantity of what the sample constitutes | 12 boxes 3 bags | From where was the sample collected | Source |
First name of sampler or witnessed by | Jesse | Last name of sampler or witnessed by | Fuentes |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 8315-PSU | Linked DIME Sample ID | 2023-12-12-29 |
The fabricator/manufacturer/facility name | Vulcan Otay | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | N/A |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | A detailed description of where the material sample was collected | Stockpile @ Plant | |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number |
Test Details
DIME Sample ID: 2023-12-12-30
DIME Test ID: 2023-12-12-30-8
Testing Lab: CT D11 - District 11 Materials Laboratory
Test Method: AASHTO T304-11: Standard Method of Test for Uncompacted Void Content of Fine Aggregate (Fine of Crushed Particles)
Test Release Date: 2024-01-17
Test Results
What test method is performed?: Method A
Input Type: Measured
Tester's full name: Shawn Rivers
Date of test: 12/19/2023
Mass of measure: 189.6 grams
Bulk dry specific gravity: 2.631
Mass of sample and measure #1: 334.7 grams
Mass of sample and measure #2: 334.1 grams
Volume of cylinder: 100 mL
Mass of sample #1: 145.1 grams
Mass of sample #2: 144.5 grams
Uncompacted voids #1: 44.8 %
Uncompacted voids #2: 45.1 %
Average uncompacted voids: 45 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 1/17/2024 ✔