Summary for Test 2023-04-26-95-3
Test performed: AASHTO T11-5Project Information
Project Identifiers | Project ID: 994350 DEA: 070W1204 EFIS: 0721000060 |
---|---|
DIST-CO-RTE-PM | 07-LA-2-24.4/46.0 |
Award Date | 01/20/2023 |
Closeout Date | 11/02/2023 |
Work Description | SLURRY SEAL. |
Location Description | LOS ANGELES COUNTY IN AND NEAR LA CANADA FLINTRIDGE AND PASADENA FROM ROUTE 2/210 SEPARATION TO 3.3 MILES EAST OF UPPER BIG TUJUNGA CANYON ROAD |
QA Service Level | 1 (Verified on 07/24/2023) |
Sample Information
Sample Taken Date | 04/26/2023 | Sample Unique Key | 95 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | No | Date that the sample was received by the laboratory/organization performing the testing | 04/27/2023 |
Sample type | Department Acceptance | A brief description of the sample | 3/4 HMA-A |
The quantity of what the sample constitutes | 600 Tons | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | victor | Last name of sampler or witnessed by | Pham |
Title of sampler | Telephone number of sampler | 2137924794 | |
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | All American Asphalt - Irwindale | Transportation Laboratory (TL) Number | 0426A1 |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-33-0005 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | 3/4 HMA-A | The fabricator/manufacturer designation for the sample | Mix 105793 |
The plant number | Irwindale | A detailed description of where the material sample was collected | Belt Discharge |
Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
The concrete mix design number | 105793 | Lot number | |
Sublot number | Aggregate Mix Number |
Test Details
DIME Sample ID: 2023-04-26-95
DIME Test ID: 2023-04-26-95-3
Testing Lab: CT D07 - Plant Services
Test Method: AASHTO T11-5: Standard Method of Test for Materials Finer Than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing
Test Release Date: 2023-05-24
Test Results
Input Type: Measured
Tester's full name: S.J/R.G
Date of test: 04/26/2023
Which test procedure is being used: Method A
Mass of test sample (before test): 509 grams
Mass of test sample (after test): 471 grams
Percent of sample passing the #200 sieve (by mass): 7.5 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 5/24/2023 ✔