Summary for Test 2022-09-19-12-8
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 993649 DEA: 081M0304 EFIS: 0821000062 |
---|---|
DIST-CO-RTE-PM | 08-RIV-177-0.0/27.0 |
Award Date | 05/23/2022 |
Closeout Date | 03/27/2023 |
Work Description | PLACE RUBBERIZED HMA, TRAFFIC STRIPING & COLD PLANE ASPHALT CONCRETE. |
Location Description | RIVERSIDE COUNTY NEAR DESERT CENTER FROM ROUTE 10/177 SEPARATION TO ROUTE 62 |
QA Service Level | 1 (Verified on 07/27/2022) |
Sample Information
Sample Taken Date | 09/19/2022 | Sample Unique Key | 12 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 09/21/2022 |
Sample type | Verification | A brief description of the sample | JMF 1/2" RHMA-G-SP 0.3% EVO |
The quantity of what the sample constitutes | 8 Bags Agg., 1 Bag MF | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | MM | Last name of sampler or witnessed by | QC |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 0652G-22 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | Martin Marietta -Coachella | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-33-0084 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
The plant number | 41218180 | A detailed description of where the material sample was collected | Belt Cut at Martin Marietta Coachella |
Where the material sample would have been placed if not sampled | Asphalt Paving | Primary Aggregate Nominal Size | 1/2 inch |
The concrete mix design number | Lot number | ||
Sublot number | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2022-09-19-12
DIME Test ID: 2022-09-19-12-8
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2022-11-09
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 09/27/2022
Weighted percentage of particles (by mass) that were flat and elongated: 0 %
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 11/9/2022 ✔