Summary for Test 2022-02-07-1-5
Test performed: ASTM C117-17Project Information
| Project Identifiers | Project ID: 214991 DEA: 044G2104 EFIS: 0412000310 |
|---|---|
| DIST-CO-RTE-PM | 04-NAP-121-0.5/1 |
| Award Date | 05/19/2021 |
| Closeout Date | 10/09/2024 |
| Work Description | WIDEN ROADWAY WITH HMA & REPLACE CULVERT WITH STRUCTURAL CONC BRIDGE. |
| Location Description | NAPA COUNTY NEAR NAPA FROM 0.2 MILE SOUTH TO 0.3 MILE NORTH OF HUICHICA CREEK BRIDGE |
| QA Service Level | 1 (Verified on 10/19/2020) |
Sample Information
| Sample Taken Date | 02/07/2022 | Sample Unique Key | 1 |
|---|---|---|---|
| Date that the sample was received by the laboratory/organization performing the testing | 02/07/2022 | Sample type | Quality Control |
| A brief description of the sample | 1/2", 3/8", and Sand | The quantity of what the sample constitutes | 1 Bucket of 1/2", 1 Bucket of 3/8", One Bucket of Sand |
| From where was the sample collected | Manufacturer | First name of sampler or witnessed by | Mark Patrick |
| Last name of sampler or witnessed by | Baddu | Title of sampler | |
| Telephone number of sampler | Laboratory sample identification | ||
| Linked DIME Sample ID | The fabricator/manufacturer/facility name | Con-Fab California, LLC | |
| Transportation Laboratory (TL) Number | Inspector Lot Number from the Transportation Laboratory (TL) Form | ||
| Structure unique identifier | Structure name | ||
| Bid Item | Not set |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | Con-Fab California, LLC |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | A detailed description of where the material sample was collected | Stockpile @ Plant | |
| Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 1/2 inch | |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2022-02-07-1
DIME Test ID: 2022-02-07-1-5
Testing Lab: Con-Fab California Corporation - Lathrop
Test Method: ASTM C117-17: Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing
Test Release Date: 2022-02-10
Test Results
Input Type: Calculated
Tester's full name: Mark Patrick Baddu
Date of test: 02/10/2022
The method used?: Procedure A
Percent finer than No. 200 sieve: 1.3 %
General comments (publicly viewable) (Max 1000 characters): Fine Aggregates
Test was verified on 2/10/2022 ✔