Summary for Test 2021-09-27-70-5
Test performed: ASTM D4791-10Project Information
| Project Identifiers | Project ID: 215744 DEA: 033H93U4 EFIS: 0321000091 |
|---|---|
| DIST-CO-RTE-PM | 03-YUB,BUT-70-25.5/25.8,0.0/3.8 |
| Award Date | 07/15/2021 |
| Closeout Date | 07/15/2025 |
| Work Description | WIDEN ROADWAY & SHOULDER, ADD TURN LANES & CONSTRUCT BRIDGE. |
| Location Description | YUBA AND BUTTE COUNTIES ABOUT 11 MILES NORTH OF MARYSVILLE FROM 0.8 MILE NORTH OF CHANDLER ROAD TO 0.2 MILE SOUTH OF EAST GRIDLEY ROAD |
| QA Service Level | 1 (Verified on 05/20/2021) |
Sample Information
| Sample Taken Date | 09/27/2021 | Sample Unique Key | 70 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 09/28/2021 |
| Sample type | Verification | A brief description of the sample | 1/2" Virgina Aggregate |
| The quantity of what the sample constitutes | Bags of Aggregate for JMF | From where was the sample collected | Supplier |
| First name of sampler or witnessed by | Kenny | Last name of sampler or witnessed by | McHugh |
| Title of sampler | Telephone number of sampler | ||
| Laboratory sample identification | Linked DIME Sample ID | ||
| The fabricator/manufacturer/facility name | Teichert Construction | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name | Bid Item | Not set |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-58-0006::HALLWOOD PLANT |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | A detailed description of where the material sample was collected | Belt Feed | |
| Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 1/2 inch | |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2021-09-27-70
DIME Test ID: 2021-09-27-70-5
Testing Lab: CT D03 - Olivehurst Northern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2021-12-27
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Mario Munoz
Date of test: 09/29/2021
Weighted percentage of particles (by mass) that were flat and elongated: 99 %
Weighted percentage of particles (by mass) that were not flat and elongated: 1 %
General comments (publicly viewable) (Max 1000 characters): JMF21-039
Test was verified on 12/27/2021 ✔