Summary for Test 2020-04-15-41-5
Test performed: ASTM D4791-10Project Information
| Project Identifiers | Project ID: 214642 DEA: 031G6704 EFIS: 0319000117 |
|---|---|
| DIST-CO-RTE-PM | 03--- |
| Award Date | 03/17/2020 |
| Closeout Date | 01/13/2021 |
| Work Description | COLD PLANE AC PAVEMENT AND RHMA-G OVERLAY. |
| Location Description | GLENN COUNTY NEAR WILLOWS FROM 2.3 MILES EAST OF NYE CREEK BRIDGE TO 0.2 MILE WEST OF ROUTE 162/5 SEPARATION |
| QA Service Level | 1 (Verified on 03/24/2020) |
Sample Information
| Sample Taken Date | 04/15/2020 | Sample Unique Key | 41 |
|---|---|---|---|
| Date that the sample was received by the laboratory/organization performing the testing | 04/16/2020 | Sample type | Verification |
| A brief description of the sample | 3/4" RHMA-G | The quantity of what the sample constitutes | JMF Verification |
| From where was the sample collected | Manufacturer | First name of sampler or witnessed by | Brad |
| Last name of sampler or witnessed by | Mckeehan (WITNESS) | Title of sampler | Knife River Construction personnel |
| Telephone number of sampler | Laboratory sample identification | JMF20-016 | |
| Linked DIME Sample ID | The fabricator/manufacturer/facility name | KRC Orland Drum Plant | |
| Transportation Laboratory (TL) Number | C779099 | Inspector Lot Number from the Transportation Laboratory (TL) Form | |
| Structure unique identifier | Structure name | ||
| Bid Item | Not set |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-11-0007 |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | The fabricator/manufacturer designation for the sample | ||
| The plant number | A detailed description of where the material sample was collected | Cold Feed | |
| Where the material sample would have been placed if not sampled | Primary Aggregate Nominal Size | 3/4 inch | |
| The concrete mix design number | Lot number | ||
| Sublot number | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2020-04-15-41
DIME Test ID: 2020-04-15-41-5
Testing Lab: CT D03 - Olivehurst Northern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2021-01-11
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Thom Stinnett
Date of test: 04/24/2020
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters): JMF20-016. Test date estimated.
Test was verified on 1/11/2021 ✔