Search Test Methods
Use this page to search for test methods that are currently supported in DIME. Enter part of the test method name, number or standard (ASTM, CTM, etc.) to filter the results. If you do not find a test method and you would like it to be added to DIME, please contact your METS Representative.
Displaying 381-400 of 405 results.
| Test Org | Prefix | Number | Version | Name | Part | Material Type | Sample Card |
|---|---|---|---|---|---|---|---|
| AASHTO | TP | 132 | 23 | Determining the Dynamic Modulus for Asphalt Mixtures Using Small Specimens in the Asphalt Mixture Performance Tester (AMPT) | Hot Mix Asphalt | View | |
| ASTM | WK | 86870 | 0 | New Test Method for Determination of Rutting Resistance Using High Temperature Indirect Tensile (HT-IDT) Strength of Asphalt Mixtures | Hot Mix Asphalt | View | |
| CTM | 435 | 21 | Method of Test for Two-Component, Type A and AL Joint Seals | Cone | Asphalt Plug Joint Seal | View | |
| CTM | 435 | 21 | Method of Test for Two-Component, Type A and AL Joint Seals | Notch | Asphalt Plug Joint Seal | View | |
| AASHTO | T | 49 | 22 | Standard Method of Test for Penetration of Bituminous Materials | Asphaltic Emulsion | View | |
| ASTM | D | 5 | 20 | Standard Test Method for Penetration of Bituminous Materials | Asphalt Binder | View | |
| AASHTO | T | 315 | 24 | Standard Method of Test for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR) | Dynamic Shear | Asphalt Binder | View |
| AASHTO | T | 48 | 20 | Standard Method of Test for Flash Point of Asphalt Binder by Cleveland Open Cup | Asphalt Binder Asphaltic Emulsion | View | |
| AASHTO | T | 240 | 23 | Standard Method of Test for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test) | Asphalt Binder Asphaltic Emulsion | View | |
| AASHTO | R | 28 | 22 | Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel | PAV | Asphalt Binder | View |
| AASHTO | T | 316 | 22 | Standard Method of Test for Viscosity Determination of Asphalt Binder Using Rotational Viscometer | Asphalt Binder | View | |
| ASTM | D | 217 | 21 | Standard Test Methods for Cone Penetration of Lubricating Grease | Cone Penetration | Asphalt Rubber Binder Asphalt Binder | View |
| ASTM | D | 5329 | 20 | Standard Test Methods for Sealants and Fillers, Hot-Applied, for Joints and Cracks in Asphalt Pavements and Portland Cement Concrete Pavements | Asphalt Pavement | Asphalt Rubber Binder Asphalt Binder | View |
| ASTM | C | 114 | 23-24 | Blended Cement Chemical Analysis: ASTM C114 (sections 7,16,17,18) & ASTM C595 | Cementitious | View | |
| ASTM | C | 114 | 23-24 | Slag Cement Chemical Analysis: ASTM C114 (17.2) & ASTM C989 | Cementitious | View | |
| ASTM | C | 114 | 23-24 | Portland Cement Chemical Analysis: ASTM C114 (sections 7,16,17,18,) & ASTM C150 | Cementitious | View | |
| AASHTO | T | 255 | 25 | Standard Method of Test for Total Evaporable Moisture Content of Aggregate by Drying | Aggregate | View | |
| AASHTO | T | 166 | 25 | Standard Method of Test for Bulk Specific Gravity (Gmb) of Compacted Asphalt Mixtures Using Saturated Surface-Dry Specimens | Method A | Hot Mix Asphalt | View |
| AASHTO | T | 209 | 25 | Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures | Maximum Specific Gravity | Aggregate Reclaimed Asphalt Pavement Hot Mix Asphalt Partial Depth Recycling | View |
| AASHTO | T | 331 | 25 | Standard Method of Test for Bulk Specific Gravity (Gmb) and Density of Compacted Asphalt Mixtures Using Automatic Vacuum Sealing Method | Partial Depth Recycling | View |