Sample Record for 2021-04-01-32
Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.
Project Information
Project ID: 215062 DEA: 030F2904 EFIS: 0314000101
QA Service Level: 1
DIST-CO-RTE-PM: 03-BUT-99-14.9/15.7
Work Description: CONSTRUCT BRIDGE AND ROADWAY; & REMOVE BRIDGE.
Location Description: BUTTE COUNTY ABOUT 10 MILES NORTH OF GRIDLEY FROM 0.3 MILE SOUTH TO 0.5 MILE NORTH OF NELSON AVENUE
Contractor Name: A. TEICHERT & SON, INC. DBA TEICHERT CONSTRUCTION
Contractor Address: 400 Sunrise Ave Ste 300,, Roseville, CA 95661
Resident Engineer: Daniel Rechs Structure Rep.: James Ralston
Sample Information
DIME Sample ID: 2021-04-01-32
TL Number from the TL Form: C706327
Sample Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Sample Organization Contact: (530) 741-4238
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 04/01/2021
Date that the sample was received by the laboratory/organization performing the testing: 04/01/2021
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: 3/4" (Nominal Size) Untreated Virgin Aggregate
From where was the sample collected: Manufacturer
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Teichert - Hallwood Plant
Material Information
Source Identification (SMARA, name of Pit or Job Site): 91-58-0006::HALLWOOD PLANT
The fabricator's/manufacturer's product name for the sample:
The fabricator/manufacturer designation for the sample:
The plant number:
A detailed description of where the material sample was collected: Cold Feed
Where the material sample would have been placed if not sampled:
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number:
Lot number:
Sublot number:
Aggregate Mix Number:
Test Results
Test 1 of 9
DIME Test ID: 2021-04-01-32-1
Test Method: AASHTO T335-09r13: Standard Method of Test for Determining the Percentage of Fracture in Coarse Aggregate (Percent of Crushed Particles)
Verified Date: 06/02/2021
Date Tested: 04/19/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
Method
|
2 - Individual Fracture Determination
|
Aggregate Size and Fracture Type
|
Coarse 1 and 2 Faced and Fine 1 Faced
|
Weighted average percentage of fractured, coarse, 2 faced particles
|
92 %
|
Weighted average percentage of fractured, coarse, 1 faced particles
|
96 %
|
Percentage of fractured, fine, 1 faced particles tested
|
99 %
|
Test 2 of 9
DIME Test ID: 2021-04-01-32-2
Test Method: AASHTO T96-02r10: Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (Los Angeles Rattler)
Verified Date: 06/02/2021
Date Tested: 04/21/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
Grading designation
|
C
|
Percent loss after 100 revolutions
|
4 %
|
Percent loss after 500 revolutions
|
18 %
|
Test 3 of 9
DIME Test ID: 2021-04-01-32-3
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Verified Date: 06/02/2021
Date Tested: 04/20/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
Test 4 of 9
DIME Test ID: 2021-04-01-32-4
Test Method: AASHTO T304-11: Standard Method of Test for Uncompacted Void Content of Fine Aggregate (Fine of Crushed Particles)
Verified Date: 06/02/2021
Date Tested: 04/16/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
What test method is performed?
|
Method A
|
Bulk dry specific gravity
|
2.692
|
Average uncompacted voids
|
47.4 %
|
Test 5 of 9
DIME Test ID: 2021-04-01-32-5
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Verified Date: 06/02/2021
Date Tested: 04/16/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B. Thomas Stinnett
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
Method
|
B
|
Determination
|
By Mass
|
Dimensional ratio used
|
5:1
|
Weighted percentage of particles (by mass) that were flat and elongated
|
99 %
|
Weighted percentage of particles (by mass) that were not flat and elongated
|
1 %
|
Test 6 of 9
DIME Test ID: 2021-04-01-32-6
Test Method: CTM 204-June 2010: Method of Test for Liquid Limit, Plastic Limit and Plasticity Index of Soils (Plasticity Index)
Verified Date: 06/02/2021
Date Tested: 04/19/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
Plastic Index(PI)
|
0
|
Liquid Limit (LL)
|
0 %
|
Plastic Limit (PL)
|
0 %
|
Test 7 of 9
DIME Test ID: 2021-04-01-32-7
Test Method: AASHTO T85-13: Standard Method of Test for Specific Gravity and Absorption of Coarse Aggregate (Coarse Specific Gravity)
Verified Date: 06/02/2021
Date Tested: 04/20/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: not applicable
Additional Comments When Verified: JMF21-020B
Basis for relative density testing
|
Bulk
|
Specific Gravity
|
2.786
|
Absorption
|
0.7 %
|
Test 8 of 9
DIME Test ID: 2021-04-01-32-8
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 06/02/2021
Date Tested: 04/16/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B. Thomas Stinnett
Test Result Compliance: not applicable
Additional Comments When Verified: JMF21-020B
Bulk specific gravity
|
2.692
|
Bulk specific gravity (SSD Basis)
|
2.741
|
Apparent specific gravity
|
2.832
|
Absorption
|
1.8 %
|
Test 9 of 9
DIME Test ID: 2021-04-01-32-9
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 06/02/2021
Date Tested: 04/15/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-020B.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-020B
What type of gradation is being tested?
|
HMA Gradation
|
Cumulative percent passing the 1 1/2 in. sieve
|
100 %
|
Cumulative percent passing the 1 in. sieve
|
100 %
|
Cumulative percent passing the 3/4 in. sieve
|
100 %
|
Cumulative percent passing the 1/2 in. sieve
|
82 %
|
Cumulative percent passing the 3/8 in. sieve
|
70 %
|
Cumulative percent passing the #4 sieve
|
45 %
|
Cumulative percent passing the #8 sieve
|
32 %
|
Cumulative percent passing the #16 sieve
|
22 %
|
Cumulative percent passing the #30 sieve
|
14 %
|
Cumulative percent passing the #50 sieve
|
9 %
|
Cumulative percent passing the #100 sieve
|
6 %
|
Cumulative percent passing the #200 sieve
|
3.5 %
|