Summary for Test 2020-08-06-9-7

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 214775
DEA: 081F13U4
EFIS: 0819000074
DIST-CO-RTE-PM08-SBD-62,95-122.0/142.7,9.7/33.6
Award Date05/04/2020
Closeout Date06/30/2021
Work DescriptionCOLD-IN PLACE RECYCLING AND PLACE RHMA-G.
Location DescriptionSAN BERNARDINO COUNTY ON ROUTE 62 FROM 3.8 MILES WEST OF ROUTE 95 TO ARIZONA STATE LINE AND ON ROUTE 95 FROM ROUTE 62 TO 2.0 MILES SOUTH OF TURTLE MOUNTAIN ROAD
QA Service Level1 (Verified on 08/14/2020)

Sample Information

Sample Taken Date08/06/2020 Sample Unique Key9
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing08/07/2020
Sample typeVerification A brief description of the samplePSUE 1/2" RHMA-G 0.5% LAS
The quantity of what the sample constitutes13 Bags Aggregate From where was the sample collectedManufacturer
First name of sampler or witnessed byMatthew Last name of sampler or witnessed byMcLuckie
Title of sampler Telephone number of sampler
Laboratory sample identification0482G-20 Linked DIME Sample ID
The fabricator/manufacturer/facility nameGranite Construction Company- Indio Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)91-33-0072
The fabricator's/manufacturer's product name for the sample1/2 RHMA-G-SP The fabricator/manufacturer designation for the sample
The plant number1346 A detailed description of where the material sample was collectedBelt Cut at Granite Indio Plant
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size1/2 inch
The concrete mix design number Lot number
Sublot number Aggregate Mix NumberNot set

Test Details

DIME Sample ID: 2020-08-06-9
DIME Test ID: 2020-08-06-9-7
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2020-08-12

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 08/11/2020
Weighted percentage of particles (by mass) that were flat and elongated: 0 %
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 8/12/2020