Summary for Test 2020-06-05-34-6
Test performed: AASHTO T324-14Project Information
Project Identifiers | Project ID: 213762 DEA: 032F3404 EFIS: 0300020616 |
---|---|
DIST-CO-RTE-PM | 03-PLA-49-3.1/7.5 |
Award Date | 02/28/2019 |
Closeout Date | 05/11/2022 |
Work Description | WIDEN SHOULDERS, ADD RETAINING WALLS, REPLACE MBGR, CURBS & ELECTRICAL |
Location Description | PLACER COUNTY IN AND NEAR AUBURN FROM 0.1 MILE SOUTH OF ROUTE 49/80 SEPARATION TO 0.1 MILE NORTH OF DRY CREEK ROAD |
QA Service Level | 1 (Verified on 01/08/2019) |
Sample Information
Sample Taken Date | 06/05/2020 | Sample Unique Key | 34 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 06/05/2020 |
Sample type | Verification | A brief description of the sample | 3/4 inch RHMA-G |
The quantity of what the sample constitutes | JMF Verification | From where was the sample collected | Source |
First name of sampler or witnessed by | Mack | Last name of sampler or witnessed by | Abott |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | KRC Hallwood at plant | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Hot Mix Asphalt | HMA Type | RHMA-G |
---|---|---|---|
HMA Grading | 1/2 inch | Lot number | |
Sublot number | HMA Mix Number | Not set |
Test Details
DIME Sample ID: 2020-06-05-34
DIME Test ID: 2020-06-05-34-6
Testing Lab: CT D03 - Olivehurst Northern Regional Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2020-08-24
Test Results
Input Type: Calculated
Tester's full name: Jeff Herbert
Date of test: 06/05/2020
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average: 20000
Impression at specified number of passes average: 5.83 mm
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 5.55 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 5.51 mm
Stripping Inflection Point (Wheel A): >25000
Stripping Inflection Point (Wheel B): >25000
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 8/24/2020 ✔