Summary for Test 2020-04-23-18-5
Test performed: ASTM D4791-10Project Information
| Project Identifiers | Project ID: 214591 DEA: 051M2704 EFIS: 0519000089 |
|---|---|
| DIST-CO-RTE-PM | 05-SB-150-0.0/2.2 |
| Award Date | 02/14/2020 |
| Closeout Date | 08/23/2021 |
| Work Description | RHMA OVERLAY, FULL WIDTH SEGMENT CORRECTION AND COLD PLANE AC. |
| Location Description | SANTA BARBARA COUNTY IN AND NEAR CARPINTERIA FROM ROUTE 101/150 SEPARATION TO VENTURA COUNTY LINE |
| QA Service Level | 1 (Verified on 05/29/2020) |
Sample Information
| Sample Taken Date | 04/23/2020 | Sample Unique Key | 18 |
|---|---|---|---|
| Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 05/07/2020 |
| Sample type | Verification | A brief description of the sample | Virgin and LSM aggregates |
| The quantity of what the sample constitutes | One JMF Verification | From where was the sample collected | Manufacturer |
| First name of sampler or witnessed by | Mark | Last name of sampler or witnessed by | Bennet |
| Title of sampler | Telephone number of sampler | ||
| Laboratory sample identification | Linked DIME Sample ID | ||
| The fabricator/manufacturer/facility name | Vulcan Saticoy | Transportation Laboratory (TL) Number | |
| Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
| Structure name |
Material Information
| Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-19-0035::FISH CANYON QUARRY |
|---|---|---|---|
| The fabricator's/manufacturer's product name for the sample | Unknown | The fabricator/manufacturer designation for the sample | Unknown |
| The plant number | Unknown | A detailed description of where the material sample was collected | At the Plant |
| Where the material sample would have been placed if not sampled | Unknown | Primary Aggregate Nominal Size | 3/4 inch |
| The concrete mix design number | Unknown | Lot number | Unknown |
| Sublot number | Unknown | Aggregate Mix Number | Not set |
Test Details
Test Details QR Code
Scan this code to open this Test Details view on another device.
Sample Details QR Code
Scan this code to open this Sample Details view on another device.
DIME Sample ID: 2020-04-23-18
DIME Test ID: 2020-04-23-18-5
Testing Lab: CT D05 - San Luis Obispo District Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2020-05-22
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: A
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Daniel Gingras
Date of test: 05/20/2020
Weighted percentage of particles (by mass) that were flat: 0 %
Weighted percentage of particles (by mass) that were elongated: 0 %
Weighted percentage of particles (by mass) that were both flat and elongated: 0 %
Weighted percentage of particles (by mass) that were neither flat nor elongated: 100 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 5/22/2020 ✔