Summary for Test 2019-03-25-18-7
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 213691 DEA: 074W2904 EFIS: 0718000114 |
---|---|
DIST-CO-RTE-PM | 07-VEN-118-0.4/11.0 |
Award Date | 12/04/2018 |
Closeout Date | 02/20/2020 |
Work Description | REPLACE ASPHALT CONCRETE SURFACING AND APPLY SLURRY SEAL COAT. |
Location Description | VENTURA COUNTY IN VENTURA FROM 0.2 MILE WEST OF ROUTE 118/126 SEPARATION TO ROUTE 34 |
QA Service Level | 1 (Verified on 02/20/2020) |
Sample Information
Sample Taken Date | 03/25/2019 | Sample Unique Key | 18 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 03/27/2019 |
Sample type | Verification | A brief description of the sample | 3/4 HMA-A-SP |
The quantity of what the sample constitutes | PSE 4 bags | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Vulcan Materials | Last name of sampler or witnessed by | Vulcan Materials |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 0203A-19 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | Sheldon Boulevard Big Rock Creek | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | Not set | |
Structure name | Not set |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-19-0017::SHELDON |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | 220831 | The fabricator/manufacturer designation for the sample | Unknown |
The plant number | Unknown | A detailed description of where the material sample was collected | Manufaturer |
Where the material sample would have been placed if not sampled | Unknown | Primary Aggregate Nominal Size | 3/4 inch |
The concrete mix design number | Unknown | Lot number | Unknown |
Sublot number | Unknown | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2019-03-25-18
DIME Test ID: 2019-03-25-18-7
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2019-04-30
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 1:5
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 04/02/2019
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 4/23/2019 ✔