Summary for Test 2018-05-15-37-10

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 212679
DEA: 023E7204
EFIS: 0200020154
DIST-CO-RTE-PM02-TEH-36-42.1/46.0
Award Date12/18/2017
Closeout Date08/07/2019
Work DescriptionCOLD PLANING, PAVING, MINOR CONCRETE, ELECTRICAL AND STRIPING WORK.
Location DescriptionTEHAMA COUNTY IN AND NEAR RED BLUFF FROM EAST SAND SLOUGH BRIDGE TO 0.6 MILE EAST OF STICE ROAD
QA Service Level1 (Verified on 05/24/2018)

Sample Information

Sample Taken Date05/15/2018 Sample Unique Key37
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing05/15/2018
Sample typeVerification A brief description of the sample3/4-inch Type G Aggregate
The quantity of what the sample constitutesJMF Verification From where was the sample collectedManufacturer
First name of sampler or witnessed byCheryl Last name of sampler or witnessed byAbraham
Title of samplerTET Telephone number of samplerUnknown
Laboratory sample identificationD77386 Linked DIME Sample IDUnknown
The fabricator/manufacturer/facility nameTullis, Inc - Northstate Asphalt - Redding, CA Transportation Laboratory (TL) Number894975
Inspector Lot Number from the Transportation Laboratory (TL) Form18-09-S1 Structure unique identifierNot set
Structure nameNot set

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)91-45-0057::SHASTA RANCH AGGREGATES
The fabricator's/manufacturer's product name for the sampleUnknown The fabricator/manufacturer designation for the sampleUnknown
The plant numberUnknown A detailed description of where the material sample was collectedSamplimg Device at Plant
Where the material sample would have been placed if not sampledUnknown Primary Aggregate Nominal Size3/4 inch
The concrete mix design numberL180371 Lot numberNot set
Sublot numberNot set Aggregate Mix NumberNot set
HMA PayNo

Test Details

DIME Sample ID: 2018-05-15-37
DIME Test ID: 2018-05-15-37-10
Testing Lab: CT D02 - Redding Northern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2018-08-14

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 1:5
Input Type: Calculated
Tester's full name: Mike Cruz
Date of test: 05/15/2018
Weighted percentage of particles (by mass) that were flat and elongated: 2 %
Weighted percentage of particles (by mass) that were not flat and elongated: 98 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 8/14/2018