Summary for Test 2017-12-14-4-1
Test performed: ASTM F606-14Project Information
Project Identifiers | Project ID: 212312 DEA: 100X9104 EFIS: 1013000041 |
---|---|
DIST-CO-RTE-PM | 10-SJ,TUO,STA-4,120,132-Var |
Award Date | 05/26/2017 |
Closeout Date | 04/30/2018 |
Work Description | MITIGATING SCOUR, PLACING ROCK SLOPE PROTECTION,AND REPAIRING |
Location Description | SAN JOAQUIN,STANISLAUS, AND TUOLUMNE COUNTIES AT VARIOUS LOCATIONS. |
QA Service Level | NOT VERIFIED |
Sample Information
Sample Taken Date | 12/14/2017 | Sample Unique Key | 4 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | No | Date that the sample was received by the laboratory/organization performing the testing | 12/14/2017 |
Sample type | Quality Assurance | A brief description of the sample | Threaded Bar |
The quantity of what the sample constitutes | 27 | From where was the sample collected | Distributor |
First name of sampler or witnessed by | ed | Last name of sampler or witnessed by | Fleming |
Title of sampler | Telephone number of sampler | 707-310-2029 | |
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | Portland Bolt | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | B10-334-17 | Structure unique identifier | Not set |
Structure name | Not set |
Material Information
Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | |
---|---|---|---|
Heat Number(s) | 073417 | Nut Mfg. Lot Number(s) | 17-40-005 |
Washer Mfg. Lot Number(s) | Bolt Specification | A563 Grade A | |
Bolt Length(s) | 42" | Nut Specification | 36 |
Washer Specification | NA | Finish | F2329 / A153 |
Diameter/Size | .750 | Bolt Mfg. Lot Number | |
Rocap Test Requirement(s) | Lubricant Requirements(s) |
Test Details
DIME Sample ID: 2017-12-14-4
DIME Test ID: 2017-12-14-4-1
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM F606-14: Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets (Hex Cap Screws)
Test Release Date: 2017-12-21
Test Results
Number of Samples: 1
Input Type: Measured
Tester's full name: Fred
Date of test: 12/14/2017
UTM: 400KIP
Temperature: 72
Num | Sample | Size | Area (in^2) | Peak Load (lbf) | Peak Load (kN) | Tensile Strength (psi) | Stress at Offset (psi) | Load at Offset (lbf) | Comments |
---|---|---|---|---|---|---|---|---|---|
1 | 1A | A307A 3/4!\" x 42 Stud | 0.334 | 28839 | 128 | 86344 | 60119 | 20080 | A307A Stud & Nut Proof |
General comments (publicly viewable) (Max 1000 characters): A307A Stud & Nut Proof
Test Graph
Source: Partner Data Point FileTest was verified on 12/14/2017 ✔