DIME - Test Summary

Summary for Test 2023-10-10-63-3

Test performed: CTM 202-November 2011

Project Identifiers	Project ID: 994886 DEA: 07386004 EFIS: 0722000169
DIST-CO-RTE-PM	07-LA-10-18.8/20.5
Award Date	03/13/2023
Closeout Date	Not set
Work Description	Rock blanket, plant establishment work and irrigation lines.
Location Description	CONSTRUCTION ON STATE HIGHWAY IN LOS ANGELES COUNTY IN AND NEAR LOS ANGELES FROM 0.3 MILE EAST OF STATE STREET OVERCROSSING TO 0.3 MILE WEST OF EASTERN AVENUE OVERCROSSING
QA Service Level	1 (Verified on 07/13/2023)

Sample Taken Date	10/10/2023	Sample Unique Key	63
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	10/11/2023
Sample type	Department Acceptance	A brief description of the sample	3/8 and Sand
The quantity of what the sample constitutes	21 CY	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	victor	Last name of sampler or witnessed by	Pham
Title of sampler		Telephone number of sampler	2137924794
Laboratory sample identification		Linked DIME Sample ID
The fabricator/manufacturer/facility name	Associate Ready Mix - LA	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-19-0054
The fabricator's/manufacturer's product name for the sample	Rock Blanket	The fabricator/manufacturer designation for the sample	mix 55346SP
The plant number	los a	A detailed description of where the material sample was collected	Stockpile @ Plant
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	3/8 inch
The concrete mix design number	55346SP	Lot number
Sublot number		Aggregate Mix Number

DIME Sample ID: 2023-10-10-63

DIME Test ID: 2023-10-10-63-3

Testing Lab: CT D07 - Plant Services

Test Method: CTM 202-November 2011: Method of Test for Sieve Analysis of Fine and Coarse Aggregates

Test Release Date: 2023-10-19

What size aggregate is being tested?: Fine Aggregate

Individual or cumulative mass retained on each sieve?: Cumulative Mass Retained

For Combined Gradation only, has the fine aggregate sample been reduced?: No

For Combined Gradation only, use #40 Sieve?: No

Input Type: Measured

Tester's full name: Victor Pham

Date of test: 10/12/2023

	Cumulative Mass Retained	Cumulative Percent Passing
Total mass of material in the sample	506 grams
3/8 in. sieve	0 grams	100 %
#4 sieve	22 grams	96 %
#8 sieve	116 grams	77 %
#16 sieve	189 grams	63 %
#30 sieve	264 grams	48 %
#50 sieve	374 grams	26 %
#100 sieve	456 grams	10 %
#200. sieve	489 grams	3 %
On the pan	490 grams

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 10/19/2023 ✔