Summary for Test 2023-06-14-46-13

Test performed: AASHTO T30-19

Project Information

Project IdentifiersProject ID: 215666
DEA: 11430564
EFIS: 1119000015
DIST-CO-RTE-PM11-SD-67-R6.0/24.4
Award Date03/01/2022
Closeout DateNot set
Work DescriptionCOLD PLANE, RHMA OVERLAY AND HFST, AND INSTALL CHANNELIZERS.
Location DescriptionSAN DIEGO COUNTY NEAR LAKESIDE AND RAMONA FROM 0.2 MILE NORTH OF SAN DIEGO RIVER BRIDGE TO ROUTE 78
QA Service Level1 (Verified on 07/06/2021)

Sample Information

Sample Taken Date06/14/2023 Sample Unique Key46
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing06/15/2023
Sample typeQuality Assurance A brief description of the sample1/2" HMA-A
The quantity of what the sample constitutes12 boxes 3 bags From where was the sample collectedSupplier
First name of sampler or witnessed byChris Last name of sampler or witnessed byLawless
Title of sampler Telephone number of sampler
Laboratory sample identification7207-JMFR Linked DIME Sample ID
The fabricator/manufacturer/facility nameMartin Marietta Lakeside Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)91-37-0036
The fabricator's/manufacturer's product name for the sample The fabricator/manufacturer designation for the sample
The plant number A detailed description of where the material sample was collectedPlant
Where the material sample would have been placed if not sampled Primary Aggregate Nominal Size1/2 inch
The concrete mix design number Lot number
Sublot number Aggregate Mix Number

Test Details

DIME Sample ID: 2023-06-14-46
DIME Test ID: 2023-06-14-46-13
Testing Lab: CT D11 - District 11 Materials Laboratory
Test Method: AASHTO T30-19: Standard Method of Test for Mechanical Analysis of Extracted Aggregate (Mechanical Analysis)
Test Release Date: 2023-07-11

Test Results


Does this test use 1/4 sieve?: No
Is an aggregate correction factor used?: Yes
Input Type: Measured
Tester's full name: Melchor Oronoz
Date of test: 06/22/2023
Cumulative Mass RetainedCorrection FactorCumulative Percent Passing
1475.3 grams
0.0 grams0.0 %100 %
0.0 grams0.0 %100 %
0.0 grams0.0 %100 %
0.0 grams0.0 %100 %
39.5 grams-0.4 %97 %
128.3 grams-0.3 %91 %
437.7 grams-1.9 %68 %
659.0 grams-2.2 %53 %
846.3 grams-1.9 %41 %
994.2 grams-1.5 %31 %
1163.5 grams-0.6 %21 %
1279.9 grams0.1 %13 %
1350.8 grams0.6 %9.0 %
1354.5 grams
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 7/11/2023