Summary for Test 2022-04-01-1-2
Test performed: ASTM F606-21Project Information
Project Identifiers | Project ID: 215486 DEA: 040A0204 EFIS: 0400000129 |
---|---|
DIST-CO-RTE-PM | 04-SON-1-15-15.7 |
Award Date | Not set |
Closeout Date | Not set |
Work Description | Construct roadway and bridge with structural concrete and CIDH piling |
Location Description | District-County-Route-Post Mile: 04-Son-1-R15.0/R15.7 |
QA Service Level | 1 (Verified on 04/08/2022) |
Sample Information
Sample Taken Date | 04/01/2022 | Sample Unique Key | 1 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 04/06/2022 |
Sample type | Quality Assurance | A brief description of the sample | ASTM A449 Threaded Rod |
The quantity of what the sample constitutes | 613 | From where was the sample collected | Fabricator |
First name of sampler or witnessed by | Arthur | Last name of sampler or witnessed by | Peterson |
Title of sampler | QA Inspector | Telephone number of sampler | 7073428602 |
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | UIS - Lindon Utah | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | L110-031-22 | Structure unique identifier | |
Structure name |
Material Information
Material Type | SMTL TM3 - Fastener Assembly | Rocap Number(s) | NA |
---|---|---|---|
Heat Number(s) | 58048638 | Nut Mfg. Lot Number(s) | NA |
Washer Mfg. Lot Number(s) | NA | Bolt Specification | ASTM A449 |
Bolt Length(s) | 12" | Nut Specification | NA |
Washer Specification | NA | Finish | ASTM F2329 Hot Dip |
Diameter/Size | 3/4-10 x 12 | Bolt Mfg. Lot Number | 108863 |
Rocap Test Requirement(s) | NA | Lubricant Requirements(s) | NA |
Test Details
DIME Sample ID: 2022-04-01-1
DIME Test ID: 2022-04-01-1-2
Testing Lab: CT HQ - Sacramento Structural Materials Testing Laboratory
Test Method: ASTM F606-21: Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets (Hex Cap Screws)
Test Release Date: 2022-04-29
Test Results
Number of Samples: 1
Input Type: Measured
Tester's full name: spaine
Date of test: 04/21/2022
UTM: 400kip
Temperature: 72
Num | Sample | Size | Area (in^2) | Peak Load (lbf) | Peak Load (kN) | Tensile Strength (psi) | Stress at Offset (psi) | Load at Offset (lbf) | Comments |
---|---|---|---|---|---|---|---|---|---|
1 | 1B | UNC 3/4 | 0.334 | 51159 | 227 | 153172 | 146301 | 48865 | A449 Wedge Tensile |
General comments (publicly viewable) (Max 1000 characters): A449 Wedge Tensile
Test Graph
Source: Bluehill Data Point FileTest was verified on 4/29/2022 ✔