Summary for Test 2021-03-11-12-6
Test performed: AASHTO T324-14Project Information
Project Identifiers | Project ID: 66667 DEA: JMFPP EFIS: 0019000043 |
---|---|
DIST-CO-RTE-PM | 59--- |
Award Date | Not set |
Closeout Date | Not set |
Work Description | Special project for submitting Sample information for JMF Prequalification Program. |
Location Description | Not set |
QA Service Level | NOT VERIFIED |
Sample Information
Sample Taken Date | 03/11/2021 | Sample Unique Key | 12 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 03/11/2021 |
Sample type | Verification | A brief description of the sample | 1/2" Type A HMA w 25% RAP 0.4% WMA - PG 58-22 design grade PG 64-10 |
The quantity of what the sample constitutes | 24 boxes | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Mark | Last name of sampler or witnessed by | Daniels |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | Vulcan Materials Company | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Hot Mix Asphalt | HMA Type | Type A HMA |
---|---|---|---|
HMA Grading | 1/2 inch | Lot number | |
Sublot number | HMA Mix Number | Not set |
Test Details
DIME Sample ID: 2021-03-11-12
DIME Test ID: 2021-03-11-12-6
Testing Lab: CT HQ - Sacramento Hot Mix Asphalt Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2021-04-15
Test Results
Input Type: Calculated
Tester's full name: Frank Chavez Jr
Date of test: 04/06/2021
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average: 15000
Impression at specified number of passes average: 5.32 mm
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): no data
Stripping Inflection Point (Wheel A): no data
Stripping Inflection Point (Wheel B): no data
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 4/15/2021 ✔