Summary for Test 2020-11-12-24-7

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 214228
DEA: 120N4904
EFIS: 1214000050
DIST-CO-RTE-PM12-ORA-91-R12.5/R13.9
Award Date12/18/2019
Closeout DateNot set
Work DescriptionVEHICLE ENFORCEMENT FACILITY IMPROVEMENT AT PERALTA WEIGH STATION.
Location DescriptionORANGE COUNTY IN ANAHEIM FROM 1.0 MILE EAST OF ROUTE 91/90 SEPARATION TO 0.5 MILE WEST OF WEIR CANYON ROAD UNDERCROSSING
QA Service Level1 (Verified on 08/13/2019)

Sample Information

Sample Taken Date11/12/2020 Sample Unique Key24
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing12/09/2020
Sample typeVerification A brief description of the sampleJMF 3/4" RWMA-G-SP,0.40% Evotherm
The quantity of what the sample constitutes4 Bags Combined Agg., From where was the sample collectedManufacturer
First name of sampler or witnessed byRMA Last name of sampler or witnessed byQC
Title of sampler Telephone number of sampler
Laboratory sample identification0688G-20 Linked DIME Sample ID
The fabricator/manufacturer/facility nameAll American Asphalt Corona Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA or name of Pit)91-33-0005
The fabricator's/manufacturer's product name for the sample3/4 RWMA-G-SP The fabricator/manufacturer designation for the sample
The plant number108835 A detailed description of where the material sample was collectedBelt Cut at All American Corona Plant
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size3/4 inch
The concrete mix design number Lot number
Sublot number JMF Verification ID

Test Details

DIME Sample ID: 2020-11-12-24
DIME Test ID: 2020-11-12-24-7
Testing Lab: CT - Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2020-12-30

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 12/12/2020
Weighted percentage of particles (by mass) that were flat and elongated:0 %
Weighted percentage of particles (by mass) that were not flat and elongated:100 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 12/30/2020