Summary for Test 2020-09-21-29-5
Test performed: AASHTO T324-14Project Information
Project Identifiers | Project ID: 214591 DEA: 051M2704 EFIS: 0519000089 |
---|---|
DIST-CO-RTE-PM | 05-SB-150-0.0/2.2 |
Award Date | 02/14/2020 |
Closeout Date | 08/23/2021 |
Work Description | RHMA OVERLAY, FULL WIDTH SEGMENT CORRECTION AND COLD PLANE AC. |
Location Description | SANTA BARBARA COUNTY IN AND NEAR CARPINTERIA FROM ROUTE 101/150 SEPARATION TO VENTURA COUNTY LINE |
QA Service Level | 1 (Verified on 05/29/2020) |
Sample Information
Sample Taken Date | 09/21/2020 | Sample Unique Key | 29 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 09/22/2020 |
Sample type | Verification | A brief description of the sample | Boxes of RHMA-G |
The quantity of what the sample constitutes | One JMF Verification | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Mark | Last name of sampler or witnessed by | Bennett |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | Vulcan Saticoy | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Hot Mix Asphalt | HMA Type | RHMA-G |
---|---|---|---|
HMA Grading | 1/2 inch | Lot number | |
Sublot number | HMA Mix Number | Not set |
Test Details
DIME Sample ID: 2020-09-21-29
DIME Test ID: 2020-09-21-29-5
Testing Lab: CT D05 - San Luis Obispo District Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2020-09-25
Test Results
Input Type: Calculated
Tester's full name: E. Atkins
Date of test: 09/25/2020
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average: 15000
Impression at specified number of passes average: 3.88 mm
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 15000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 15000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 3.62 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 4.14 mm
Stripping Inflection Point (Wheel A): >20000
Stripping Inflection Point (Wheel B): >20000
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 9/25/2020 ✔