Summary for Test 2020-07-07-5-7

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 214774
DEA: 081F1324
EFIS: 0815000212
DIST-CO-RTE-PM08-SBD-95-64.5/80.5
Award Date05/04/2020
Closeout Date01/18/2022
Work DescriptionPLACE RHMA-G, COLD PLANE AC AND REPLACE AC SURFACING.
Location DescriptionSAN BERNARDINO COUNTY ON ROUTE 95 FROM 0.5 MILE NORTH OF GOFFS ROAD TO NEVADA STATE LINE.
QA Service Level1 (Verified on 08/25/2020)

Sample Information

Sample Taken Date07/07/2020 Sample Unique Key5
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing07/09/2020
Sample typeVerification A brief description of the sampleJMF 3/4" HMA-A-SP 0.25% EVO
The quantity of what the sample constitutes13 Bags Agg., 2 Bags WCF, 2 Bags CF From where was the sample collectedManufacturer
First name of sampler or witnessed byAustin Last name of sampler or witnessed byBeeler
Title of sampler Telephone number of sampler
Laboratory sample identification0414A-20 Linked DIME Sample ID
The fabricator/manufacturer/facility nameVulcan-Bullhead City Arizona Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)CM2056
The fabricator's/manufacturer's product name for the sample3/4 HMA-A-SP The fabricator/manufacturer designation for the sampleUnknown
The plant number238111B A detailed description of where the material sample was collectedBelt Cut at Vulcan Bullead City Plant
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size3/4 inch
The concrete mix design numberUnknown Lot numberUnknown
Sublot numberUnknown Aggregate Mix NumberNot set

Test Details

DIME Sample ID: 2020-07-07-5
DIME Test ID: 2020-07-07-5-7
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2020-07-21

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 07/15/2020
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 7/21/2020