Summary for Test 2020-05-06-16-5
Test performed: AASHTO T324-14Project Information
Project Identifiers | Project ID: 214520 DEA: 051H9804 EFIS: 0517000043 |
---|---|
DIST-CO-RTE-PM | 05-SB-101-78.4/79.0 |
Award Date | 01/08/2020 |
Closeout Date | 09/25/2020 |
Work Description | ROADWAY EXCAVATION, PLACE AGGREGATE BASE, HMA AND RHMA-G. |
Location Description | SANTA BARBARA COUNTY NEAR SANTA MARIA FROM 0.3 MILE SOUTH TO 0.3 MILE NORTH OF SOLOMON SUMMIT UNDERCROSSING |
QA Service Level | 1 (Verified on 02/20/2020) |
Sample Information
Sample Taken Date | 05/06/2020 | Sample Unique Key | 16 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 05/13/2020 |
Sample type | Verification | A brief description of the sample | Boxes of RHMA-G |
The quantity of what the sample constitutes | One JMF Verification | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Cal | Last name of sampler or witnessed by | Portland |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | Linked DIME Sample ID | ||
The fabricator/manufacturer/facility name | CalPortland Garey | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | ||
Structure name |
Material Information
Material Type | Hot Mix Asphalt | HMA Type | RHMA-G |
---|---|---|---|
HMA Grading | 3/4 inch | Lot number | Unknown |
Sublot number | Unknown | HMA Mix Number | Not set |
Test Details
DIME Sample ID: 2020-05-06-16
DIME Test ID: 2020-05-06-16-5
Testing Lab: CT D05 - San Luis Obispo District Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2020-05-19
Test Results
Input Type: Calculated
Tester's full name: D. Ramirez
Date of test: 05/18/2020
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average: no data
Impression at specified number of passes average: no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 15000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 15000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 3.05 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 3.05 mm
Stripping Inflection Point (Wheel A): >16600
Stripping Inflection Point (Wheel B): >16600
General comments (publicly viewable) (Max 1000 characters): CPD 19-8 CCO looks at average rut depth at 15000 passes for PG 64-16, and inflection point is report only.
Test was verified on 5/19/2020 ✔