Summary for Test 2020-04-02-7-7

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 213707
DEA: 081C38U4
EFIS: 0817000196
DIST-CO-RTE-PM08-RIV-10-6.7/R25.1
Award DateNot set
Closeout DateNot set
Work DescriptionRemove concrete pavement and base, and place HMA and JPCP
Location DescriptionROUTE 10/60 SEPARATION IN BEAUMONT TO ROUTE 10/111 SEPARATION NEAR CABAZON.
QA Service Level1 (Verified on 01/09/2020)

Sample Information

Sample Taken Date04/02/2020 Sample Unique Key7
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing04/07/2020
Sample typeVerification A brief description of the sample3/4 HMA-A-SP R24
The quantity of what the sample constitutesJMF 3 Bags From where was the sample collectedManufacturer
First name of sampler or witnessed byClawlass Last name of sampler or witnessed byDwelcer
Title of sampler Telephone number of sampler
Laboratory sample identification0186A-20 Linked DIME Sample ID
The fabricator/manufacturer/facility nameCalifornia Commercial Asphalt - Lake Elsinore Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA or name of Pit)91-33-0098, 91-33-0011
The fabricator's/manufacturer's product name for the sample3/4 HMA-A-SP R24 The fabricator/manufacturer designation for the sampleUnknown
The plant number53417615 A detailed description of where the material sample was collectedBelt Cut at California Commercial Asphalt Lake Elsinore Plant
Where the material sample would have been placed if not sampledAsphalt Paving Primary Aggregate Nominal Size3/4 inch
The concrete mix design numberUnknown Lot numberUnknown
Sublot numberUnknown JMF Verification ID

Test Details

DIME Sample ID: 2020-04-02-7
DIME Test ID: 2020-04-02-7-7
Testing Lab: CT - Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2020-05-06

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Michael Magana
Date of test: 04/09/2020
Weighted percentage of particles (by mass) that were flat and elongated:2 %
Weighted percentage of particles (by mass) that were not flat and elongated:98 %
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 5/6/2020